![background image](/i/bosch/167061/bosch-tes-50328-rw/h/bosch-tes-50328-rw-010.png)
6
en
Robert Bosch Hausgeräte GmbH
Switching on the appliance
1. Place the fully automatic espresso ma-
chine on a l at, water-resistant surface
that can take its weight. Make sure that
the machine’s ventilation slots remain
unobstructured.
2. Pull the power cord out of the storage
compartment (20) and plug in. Adjust
the length of the cable by pushing it
back in or pulling it out. The easiest way
to do this is to place the appliance so
that its back is l ush with the edge of the
counter and either pull the cable
down-
ward
or push it
upward
.
3. Install the milk frother. Operate the ma-
chine only after the milk frother (6) has
been fully assembled and installed.
4. Lift the lid of the water tank (17).
5. Remove and rinse the water tank (16)
and i ll it with fresh cold water.
Do not i ll above the
max
mark.
6. Replace the water tank (16) and push it
i rmly downward into place.
7. Close the lid of the water tank (17)
again.
8. Fill the bean container (1) with coffee
beans. (For preparation using ground
coffee, see “Preparation using ground
coffee” on page 10.)
9. Press the power switch
O / I
(9). The
display (15) shows the menu for setting
the display language.
10. Select the required display language
with the upper rotary knob (14). The
following languages are available:
English
Nederlands
Français
Italiano
Svenska
Español
Polski
Magyar
Türkçe
Dansk
Norsk
Suomi
Português
Čeština
ελληνικα
български
русский
11. Press the
start
button (10). The
language you selected is saved. The
display shows
Pull milk frother
.
12. Place a receptacle under outlet (6c).
13. Carefully pull out the milk frother (6) to
open it. The appliance rinses out the
milk frother (6) with water. The display
shows
Push milk frother
.
14. Push the milk frother (6) in to close it.
The appliance heats up and rinses. Some
water will run out of the coffee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
Switching off the appliance
If the appliance has not been used for an
hour, it rinses automatically and then
switches off (time span can be programmed,
see “Menu settings”
Shut off
on page 8).
Exception:
The appliance switches off with-
out rinsing if only hot water or steam were
dispensed.
To switch the appliance off manually before
this, press the
e
off /
j
button (12). The
appliance rinses and switches off.
N.B.:
If the appliance is being used for the
i rst time, a service program has been run,
or the appliance has not been operated for
a long period, the i rst beverage will not
have the full aroma and should not be con-
sumed.