12

English

Use a half-round file or wood rasp to smooth out
any roughness in the speaker hole you have cut.

Using the sabre saw, cut the hole for the speaker,
carefully staying just inside the line. Take your time;
you want a smooth edged circular hole.

B 4

Installing Your Speakers From The Front Of The Bulkhead

Drill a starter hole that is large enough for your sabre
saw blade. Be sure to drill inside and close to the line
you have marked.

Mark six screw holes from the largest hole pattern on
the template, but do not drill yet. You may need to
mark and drill a different set of holes along the same
circle before finally attaching the flange.

Note:

These markings are important to help keep the

saw blade inside the line you have just drawn.

CAUTION: 

Be sure to stay inside the line you have

marked, and in particular, be sure to stay well inside

the hole pattern you have marked. The marked

holes, or others along the same circle, will be used to

secure the speaker and must not be too close to the

speaker hole. It is also important to stay inside the

line because any error you make could be visible

after the speaker grille is installed.

B 2

B 3

B 5