5
6
19
.
Other Problems
There is much noise when the robot
works.
Press the
” emo mode and the
machine does not react
“ D
Turn off the power supply, and then take out of
dust box. After removing the garbage, overturn
the robot.
1. Check whether the suction of main brush is
blocked.
2. Examine and clean the main brush(at both
ends)
3. Examine and clean the side brush.
If the failure is still there after operating
according to the above procedure, Please
contact out after-sales service.
1. Power off first and check if the original SD
card has been correctly assembled.
2. Ensure the SD card is correctly inserted or
not.
1.
mode?
Answer: Because when there is low battery,
Answer: It depend on the ground situation.
it will do back to charging mode
automatically.
2.
How long can robot last working under
full battery?
7
What
'
s the cleaning coverage once it is
charged full?(under automatic
cleaning
Answer: It differs from the ground situation,
mode)
It takes around 60 minutes for even floor
Answer: Under normal circumstance, it is
such as wooden floor and ceramic tile, and
around
sq, but it differs from the
20 minutes for short-haired carpet.
ground situation.
3.
Is it allowed for the robot to work
8
Why does robot stop working once it
independently without taking care of?
meets obstacle?
Answer: Yes. However, you should keep
Answer: Under normal circumstance, robot
person in the room informed about robot
will return or seek other route when it meets
operating to avoid tipping.
obstacle. However, if it controlled by remote
4.
What kind of equipment inside the robot
control, it is not able to change route in case
is used for dealing with failure?
of obstacle.
Answer: It is equipped with photosensitive
9
Why there is garbage leaking from the
components which can detect the stair over
machine
while
robot
operating?
the height of 8 centimeters; for fear that it
Answer: a. Please check whether there is
would fall over.
too much garbage in dust box(if there is too
5
Is robot able to clean the bottom of the
much dust on the floor, robot is not able to
furniture?
alarm after working for some time even
though there is too much garbage in dust
Answer: It is flat design, during normal
box.). That's why you need to clean dust
cleaning, it can go into table and bed corner
box. b. See whether main brush is not
whose height is over 10 centimeters, such as
cleaned for long time, as it is tangled with
bed, wardrobe, sofa and tea table.
much hair and dust.
6
Why does robot fail to work under set
How much reserve time for robot go back
charging?
120-150
.
.
.
.
.
E n j o y S m a r t e r L i f e !
37
E n j o y S m a r t e r L i f e !
