![background image](/i/freggia/134945/freggia-hc640vgtb-hc320vw-hc320vb-hc640vgtw/h/freggia-hc640vgtb-hc320vw-hc320vb-hc640vgtw-011.png)
GB
11
INSTRUCTIONS FOR THE USER
1 Rapid burner
3000 W
2 Semi-rapid burner 1650 W
3 Auxiliary burner
1000 W
4 Ultra-rapid burner 3500W
8 Control knobs burner
INSTRUCTIONS FOR THE USER
IT IS NECESSARY THAT ALL THE OPERATIONS REGARDING THE INSTALLATION, ADJUSTmENT AND
ADAPTATION TO THE TYPE OF GAS AvAILABLE ARE CARRIED OUT BY QUALIFIED PERSONNEL, IN
CONFORmITY WITH THE REGULATIONS IN FORCE.
THE SPECIFIC INSTRUCTIONS ARE DESCRIBED IN THE BOOKLET SECTION INTENDED FOR THE
INSTALLER
USING THE BURNERS
The symbols silk-screen printed on the side of the knob indicate the correspondence between the knob and the burner.
•
mANUAL IGNITION
Press the knob and turn it anticlockwise until it reaches the symbol on the control panel (maximum flame position)
and place a lighted match or lighter near the burner.
•
ELECTRICAL IGNITION
Press the knob and turn it anticlockwise until it reaches the symbol on the control panel (maximum flame position)
and press the button on the control panel.
On those models fitted with a safety device, the knob must be pressed in for about 6 seconds once the burner
has ignited.
•
USING THE BURNERS
In order to obtain the maximum yield without waste of gas, it is important that the diameter of the pot is suitable for
the burner potential (see the following table), so as to avoid that the flame goes out of the pot bottom (fig.1).
Use the maximum capacity to quickly make the liquids reach the boiling
temperature, and the reduced capacity to heat food or maintain boiling.
All of the operating positions must be chosen between the maximum
and the minimum ones, never between the minimum position and the
closing point.
The gas supply can be interrupted by turning the knob clockwise up
to the closing position.
DESCRIPTION
Burners
power (W)
Ø of pots
Auxiliary
1000
10 - 14 cm
Semi-rapid 1650
16 - 18 cm
Rapid
3000
20 - 22 cm
Ultra-rapid 3500
24 - 26 cm