GB

7

Electrical connection

Ovens equipped with a three-pole power supply cable are 

designed to operate with alternating current at the voltage 

and frequency indicated on the data plate located on the 

appliance (see below).

Fitting the power supply cable

1. Open the terminal board 

by inserting a screwdriver 

into the side tabs of the 

cover. Use the screwdriver 

as a lever by pushing it 

down to open the cover (see 

diagram).

2. Install the power supply 

cable by loosening the 

cable clamp screw and the 

three wire contact screws  
L-N-

.

Connect the wires to the 

corresponding terminals: 

the Blue wire to the terminal 

marked (N), the Brown wire 

to  the  terminal  marked  (L) 

and  the Yellow/Green  wire 

to the terminal marked 

(see diagram).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load 

indicated on the data plate (see table). 

The appliance must be directly connected to the mains using 

an omnipolar switch with a minimum contact opening of 3 

mm installed between the appliance and the mains.  The 

switch must be suitable for the charge indicated and must 

comply with current electrical regulations (the earthing wire 

must not be interrupted by the switch). The supply cable 

must be positioned so that it does not come into contact 

with temperatures higher than 50°C at any point (the back 

panel of the oven, for example).

!

 The installer must ensure that the correct electrical 

connection has been performed and that it is fully compliant 

with safety regulations.

Before connecting the appliance to the power supply, make 

sure that

•  The appliance is earthed and the plug is compliant with 

the law.

•  The socket can withstand the maximum power of the 

appliance, which is indicated on the data plate.

•  The voltage is in the range between the values indicated 

on the data plate.

N

L

•  The socket is compatible with the plug of the appliance. 

If the socket is incompatible with the plug, ask an 

authorised technician to replace it. Do not use extension 

cords or multiple sockets.

!

 Once the appliance has been installed, the power supply 

cable and the electrical socket must be easily accessible.

!

 The cable must not be bent or compressed.

!

 The cable must be checked regularly and replaced by 

authorised technicians only (see Assistance).

!

The manufacturer declines any liability should these 

safety measures not be observed.

APPLIANCE SPECIFICATIONS

Dimensions*

width 43.5 cm 

height 32,4 cm 

depth 41.5 cm

Volume*

59 l

Dimensions**

width 45.5 cm 

height 32,4 cm 

depth 41.5 cm

Volume**

62 l

Electrical 

connections

voltage: 220 - 240 V~ 50/60 Hz or 

50 Hz (see data plate) maximum power 

absorbed 2800 W  

ENERGY

LABEL

Without 

removable 

guide rails

Directive 2002/40/EC on the label 

of electric ovens. Standard EN 50304
Declared energy consumption 

for Forced convection Class – 

heating mode:

ECO.

* Only for models with drawn rails.

** Only for models with wire rails.

This appliance conforms to the 

following European Economic 

Community directives: 

- 2006/95/EEC dated 12/12/06 

(Low Voltage) and subsequent 

amendments 

- 2004/108/EEC dated 03/05/89 

(Electromagnetic Compatibility) 

and subsequent amendments 

- 93/68/EEC dated 22/07/93 and 

subsequent amendments. 

- 2012/19/EEC and subsequent 

amendments.

1275/2008 standby/off mode.