EN

19

Start-up and use

Measuring out the detergent

A good wash result also depends on the correct
amount of detergent being used; exceeding the
stated amount does not result in a more effective
wash and increases environmental pollution.

Only use detergent which has been specifically

designed for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle has
ended.

The use of tablets is only recommended for models

which offer the MULTI-FUNCTIONAL TABLETS
option.

To achieve the best results from each washing

and drying cycle, powder detergent, rinse aid liquid
and salt should be used.

Compartment A:

 Washing detergent

Compartment B:

 Pre-wash detergent

1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the 

Table of wash

cycles:
• For powder detergent use
compartments A and B.
• For detergent in tablet form:
when the cycle requires 1 tablet,
place it in compartment A and

close the cover; when it requires 2, place the second tablet
at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.

A

B

D

C

*

 Only available in selected models.

Starting the dishwasher

1. Turn the water tap on.
2. Open the door and press the ON/OFF button: you will hear
a short beep and the ON/OFF and wash cycle indicator lights
switch on for a few seconds.
3. Measure out the detergent (

see below).

4. Load the racks (

see chapter entitled Loading the racks).

5. Select the wash cycle in accordance with the type of
crockery and its soil level (

see Table of wash cycles), by

pressing the 

P

 button; the indicator light corresponding to

the selected wash cycle will switch on.
7. Start the wash cycle by shutting the door: after a few
seconds have passed, a long beep signals the start of the
wash cycle.
8. Two short beeps and one long one indicate the end of the
wash cycle and the indicator light corresponding to the wash
cycle flashes slowly. Open the door, switch off the appliance
by pressing the ON/OFF button, shut off the water tap and
unplug the appliance from the electricity socket.
9. Wait for a few minutes before removing the crockery, in
order to avoid burns. Unload the racks, beginning with the
lower level.

- The machine will switch off automatically during

certain periods of inactivity, in order to minimise
electricity consumption.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection process
it is possible to change the cycle, provided that it has only just
begun: open the door, taking care to avoid the escaping steam,
and press and hold the ON/OFF button; the machine will switch
off with a long beep. Switch the machine back on using the ON/
OFF button and select the new wash cycle using the P button;
start the cycle by closing the door.

Adding extra crockery

Without switching off the machine, open the door, taking care
to avoid the escaping steam, and place the crockery inside
the dishwasher. Close the door: the cycle starts from the
point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the
electricity supply is restored.