EN
10
Start-up and use
*
Only available in selected models.
Measuring out the detergent
A good wash result also depends on the correct
amount of detergent being used. Exceeding the stated
amount does not result in a more effective wash and
increases environmental pollution.
Based on how soiled the items are, the amount can be
adjusted to individual cases using powder or liquid
detergent.
In the case of normally soiled items, use approximately
either 35 gr (powder detergent) or 35 ml (liquid detergent).
If tablets are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed
with water before being placed in the dishwasher, reduce
the amount of detergent used accordingly.
For good washing results also follow the instructions shown
on the detergent box.
For further questions please ask the detergent producers'
Advice Offices.
To open the detergent dispenser use the opening device “A”.
Introduce the detergent into the dry dispenser “B” only.
Place the amount of detergent for pre-washing directly
inside the tub.
1.
When measuring out the detergent refer to the Table of wash
cycles to add the proper quantity. Compartment
B
comprises
a level showing the maximum quantity of liquid or powder
detergent that can be added to each cycle.
2.
Remove detergent residues from the edges of the dispenser
and close the cover until it clicks.
3.
Close the lid of the detergent dispenser by pulling it up until
the closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the wash cycle.
If all-in-one detergents are used, we recommend using the TABS
option, because it adjusts the cycle so that the best washing
and drying results are always achieved.
Only use detergent which has been specifically designed
for dishwashers.
DO NOT USE washing-up liquid.
Using excessive detergent may result in foam residue
remaining in the machine after the cycle has ended.
The use of tablets is only recommended for models which
offer the MULTI-FUNCTIONAL TABLETS option.
To achieve the best results from each washing and drying
cycle, powder detergent, liquid rinse aid and salt should
be used.
Starting the dishwasher
1. Turn the water tap on.
2. Press the
ON-OFF
symbol: the display lights up for a few
seconds and the text
ON
appears.
3. Open the door and pour in a suitable amount of detergent
(see Measuring out the detergent.)
4. Load the racks
(see Loading the racks)
and shut the door.
5. Press the
P
symbol to select the wash cycle based on the
type of crockery and its soil level
(see Table of wash cycles)
6. Select the wash options
*
(see Special wash cycles and
options.)
7. Press
Start/Pause
; the Start indicator light on the display lights
up. The wash cycle number, the indicator lights corresponding
to washing, any selected options and the time remaining until
the end of the cycle appear on the display.
8. Once the wash cycle has ended, its corresponding number
appears on the display along with the text
END
. Switch off
the appliance using
ON/OFF
; the text
OFF
will appear on the
display. Shut off the water tap and unplug the appliance from
the electricity socket.
9. Wait a few minutes before removing the crockery to avoid
getting burnt. Unload the racks, beginning with the lower level.
- The machine will temporarily switch off automatically
during certain extended periods of inactivity in order to
minimise electricity consumption.
AUTO WASH CYCLES
*
: this model of dishwasher is
equipped with a special sensor which can be used to assess
the level of soiling and automatically select the most efficient
and economic wash cycle accordingly. The duration of the auto
wash cycles may vary due to the operation of the sensor.
If the crockery is only lightly soiled or has been rinsed
with water before being placed in the dishwasher, reduce
the amount of detergent used accordingly.
Changing a wash cycle in progress
If a mistake was made during the wash cycle selection process,
it is possible to change the cycle, provided that it has only just
begun. To change the wash cycle, switch off the machine by
pressing and
holding down ON/OFF/Reset
; the text
3-2-1 OFF
will appear on the display. Switch the machine back on using ON/
OFF; and select the wash cycle and any desired options again.
Adding extra crockery
Press
Start/Pause
: the Pause symbol lights up. Open the door,
taking care to avoid the escaping steam, and place the crockery
inside the appliance. Press
Start/Pause
again: the Start symbol
lights up and the cycle is resumed.
Press
Start/Pause
to pause the machine; the wash cycle is
stopped temporarily.
At this stage the wash cycle cannot be changed.
Accidental interruptions
If the door is opened during the wash cycle or there is a power
cut, the cycle stops. It starts again from the point at which it
was interrupted once the door has been shut or the electricity
supply restored.
