EN
12
Special wash cycles and Options
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles)
, the
corresponding symbol/indicator light flashes rapidly 3 times.
If an option is selected which is not compatible with another
previously-selected option, it flashes 3 times and goes off, while
the option selected first will remain active.
To deselect an option which has been set by mistake, press
the corresponding symbol/button again.
Delayed start
It is possible to delay the start of the cycle for a period
of time between
1 and 24
hours.
1. After selecting the desired wash cycle and any other options,
press the DELAYED START symbol; the symbol on the display
lights up. Press the DELAYED START symbol to select the time
at which you wish the wash cycle to begin (1 to 24 hours.)
2. Confirm your selection using the Start/Pause symbol; the
countdown will begin. The selected delay period is displayed.
3. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
To deselect it, press and hold the DELAYED START symbol until
the text
OFF
appears.
The DELAYED START function cannot be set once a
wash cycle has been started.
Multi-functional tablets
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button, the indicator light will
illuminate.
The “Multi-functional tablets” option results in
the lengthening of the wash cycle.
The use of tablets is only recommended when the
MULTI-FUNCTIONAL TABLETS option is available.
This option is not recommended for use with wash
cycles which do not specify the use of multi-functional
tablets
.
Extra drying
To improve the dryness level of the crockery, press
the EXTRA DRYING button, the indicator light will illuminate.
If it is pressed again the option will be deselected.
A higher temperature during the final rinse and an extended
drying phase allow for improving drying.
The EXTRA DRYING option increases the duration of
the wash cycle.
Short Time
This option can be used to reduce the duration of
the main wash cycles while, maintaining the same washing
and drying performance levels. After selecting the wash
cycle, press the SHORT TIME button; the illumination of the
corresponding symbol/indicator light indicates its selection.
Press it again to deselect it.
Zone Wash
This option makes it possible to carry out the wash
cycle in the selected rack only. Select the wash cycle and
then press the ZONE WASH button: the selected rack lights
up and the wash cycle starts in the selected rack only. Press
the button again to deselect the option.
The option is available with the following wash cycles:
Intensive
and
Normal.
Select the option and the
Intensive
cycle to start the
ULTRAINTENSIVE ZONE washing. This wash cycle is ideal
for very soiled mixed loads, e.g. pans and saucepans,
dishes with heavy encrustation or difficult-to-clean crockery
(grater, vegetable mill, dirty cutlery). The spraying pressure is
stronger and the washing temperature higher, thus ensuring
optimum handling of stubborn stains.
Select the option and the
Normal
cycle to start the SAVING
ZONE washing. This function makes it possible to reduce
energy consumption. Cycle duration might change.
Remember to load the crockery in the selected rack only
Notes:
Optimum performance levels when using the “Fast wash”
and “Express 30’” cycles can be achieved by respecting
the specified number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories:
for information on comparative
EN testing conditions, please send an email to the following
address: ASSISTENZA_EN_LVS@indesitcompany.com
