This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are ordered, HP
recommends the use of an HP approved configurator. Contact your local sales representative for information on configurable product
offerings and requirements.
1. Factory Integrated Models must start with a CTO Server. 
2. FIO indicates that this option is only available as a factory installable option.
3. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives ordered with
the server.
4. Some options may not be integrated at the factory. Contact your local sales representative for additional information. 

Step 1: Base Configuration (choose one of the following configurable models)

[Chassis]

HP ProLiant DL560 Gen9 Configure-to-order Server

SKU Number

742657-B21

Processor

2U Server Chassis with 2 processor slots available; 4 processor configuration would
require optional HP ProLiant DL560 Gen9 CPU Mezzanine Board kit

DIMM Slots

24 DIMM slots for RDIMM, LRDIMM DDR4 Memory

Storage Controller

HP Dynamic Smart Array B140i; additional options including Flexible Smart Array, Smart
Array and Smart HBA controllers.

PCIe

4 PCIe 3.0 slots (all 4 available if second processor is chosen, which also enables +3 PCI
3.0 slots with optional Secondary Riser Kit upgrade)

Drive Cage

8SFF Hot Plug (Upgrades possible with +16SFF optional or +10 optional with optional
Universal Media Bay Kit in Bay 1 with optional 2SFF).

NOTE: 

 Server comes with Bay 3 populated as default.

Network
Controller

Flexible LOM slot (various options can be chosen for networking; NIC cards also available
via expansion slots)

Fans

6 hot plug fans, redundant

Management

HP Integrated Lights-Out 4 (iLO4) standard management, HP iLO4 Embedded Remote
Support Technology, HP Insight Control Server Provisioning, HP Insight Online, HP Active
Health System, System Insight Display

USB

(8) USB 2.0 ports (2 front, 4 rear, 2 internal)

(Base Configuration Continued)
Intel® C610 Chipset
(2) video ports (1 front optional via the Universal Media Kit upgrade option, 1 rear)
(1) dual microSD card slot
(1) Trusted Platform Module (TPM) connector
BIOS Legacy mode (field configurable) or Unified Extensible Firmware Interface (UEFI) mode (default)
Easy Install rails and cable management arm are optional
 

NOTE:

 PCIe slot availability is dependent on the number of processors installed. Please refer to the "Expansion slots" section for more

details.

NOTE:

 A minimum of one processor is required. The system supports one, two or four processors installed.

Step 2: Choose Required Options (only one of the following from each list unless
otherwise noted)

QuickSpecs

HP ProLiant DL560 Generation9 (Gen9)

Configuration Information - Factory Integrated Models

DA - 15296   Worldwide QuickSpecs — Version 3 — 8.17.2015

Page  16