Инструкция для HP Proliant DL560 Gen9 2xXeon10C E5-4620v3 2.0GHz/4x16GbR2D_2133/P440arFBWC(2GB)/SFF (741065-B21)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

To maximize performance, install two memory cartridges per processor and balance the total memory
capacity between all installed processors.

When multiple processors are installed, HP recommends installing the DIMMs in sequential alphabetical
order: 4A, 9B, 1C, 12D, and so on.

LRDIMMs support higher densities than single- and dual-rank RDIMMs, and higher speeds than quad-rank
RDIMMs. This support enables you to install more high capacity DIMMs, resulting in higher system
capacities and higher bandwidth.

Do not mix LRDIMMs with any other DIMM type (RDIMM, LVDIMM).

RDIMM population is limited to a maximum of eight logical ranks per channel. Therefore, only two quad
rank RDIMMs are supported per channel. If there are more than eight physical ranks per channel,
LRDIMMs rank multiplication provides support for three DIMMs per channel.

• Lockstep mode requires specific population requirements. See lock-step configuration below for more
information.

NOTE:

UDIMMs are not supported. This server does not support mixing LRDIMMs, RDIMMs, or UDIMMs.

Attempting to mix any combination of these DIMMs can cause the server to halt during BIOS initialization.
For detailed memory configuration rules and guidelines, use the Online DDR4 Memory Configuration Tool
on the HP website

(

http://www.hp.com/go/ddr4config

Intel Gen9 Supported Memory Bandwidth for HP ProLiant Gen9 Intel® Xeon®E5-4600v3 Series Processor
Family

Memory Bandwidth and Capacity

[DIMM Type]

Registered DIMMs (RDIMMs)

Load Reduced
(LRDIMMs)

Load Reduced (LRDIMMs)

DIMM Rank

Single Rank

Dual Rank

Quad Rank