NOTE:

 This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid

configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales
representative for information on configurable product offerings and requirements.

NOTE:

 Factory Integrated Models must start with a CTO Server

NOTE:

 FIO indicates that this option is only available as a factory installable option.

Step 1: Base Configuration

HP Models

HP ProLiant DL580 Gen9 Configure-to-order Server

793161-B21

Factory Integrated Models ship with:

4U Server Chassis with front-accessible processor and memory drawer
Intel® 602J Chipset
Embedded HP Smart Array 12 G P830i Controller

NOTE:

 FBWC is required and should be selected separately when ordering

(5) Hot-plug SAS/SATA SFF SSD or HDD Bays (Lower)
(9) PCIe Gen3.0 I/O Expansion slots (5 x16 slots; 4 x8 slots)
(8) USB 2.0 ports (2 front, 4 rear, 2 internal)
(2) video ports (1 front, 1 rear)
(1) microSD card slot
(1) Trusted Platform Module (TPM) connector
4 Hot Plug Fans (eight rotors with N+1 redundancy), front accessible
BIOS Legacy mode(field configurable) or Unified Extensible Firmware Interface
(UEFI) mode (default)
HP Integrated Lights-Out 4 (iLO4) standard management
HP iLO4 Embedded Remote Support Technology
Intelligent Provisioning
HP Insight Control Server Provisioning
HP Insight Online
HP Active Health System
System Insight Display
Rack rails and cable management arm

NOTE:

 PCIe slot availability is dependent on the number of processors installed.

Please refer to the "Expansion slots" section for more details.

NOTE:

 A minimum of two processors are required. The system may have three

or four processors installed.

NOTE:

 A minimum of two memory cartridges are required (one per processor).

NOTE:

 A minimum of two memory DIMMs are required per cartridge (minimum

of four DIMMs per server).

NOTE:

 A minimum of two power supplies are required.

Step 2: Choose Required Options (only one of the following from each list unless
otherwise noted)

HP Processors

NOTE:

 All processor kits contain one processor. Two processors are required.

Must  select one xxxxxx-L21 and at least one corresponding xxxxxx-B21.

Eighteen-Core Processors

HP DL580 Gen9 Intel® Xeon® E7-8890v3 (2.5GHz/18-core/45MB/165W) FIO
Processor Kit

788317-L21

HP DL580 Gen9 Intel® Xeon® E7-8890v3 (2.5GHz/18-core/45MB/165W)
Processor Kit

788317-B21

HP DL580 Gen9 Intel® Xeon® E7-8880v3 (2.3GHz/18-core/45MB/150W) FIO
Processor Kit

788319-L21

QuickSpecs

HP ProLiant DL580 Gen9 Server

Configuration Information - Factory Integrated Models

DA - 15187   Worldwide QuickSpecs — Version 2 — 8.17.2015

Page  20