![background image](/i/infiniti/150598/infiniti-m45-2008-m35-2008/h/infiniti-m45-2008-m35-2008-040.png)
7. Before placing the child in the child re-
straint, hold child restraint near the
LATCH attachment and use force to push
the child restraint from side to side, and
tug it forward to make sure that it is
securely held in place. It should not move
more than 1 in (25 mm). If it does move
more than 1 in (25 mm), pull again on the
anchor attachments to further tighten the
child restraint. If you are unable to prop-
erly secure the restraint, move the re-
straint to another seating position and try
again, or try a different child restraint. Not
all child restraints fit in all types of ve-
hicles.
8. Check to make sure the child restraint is
properly secured prior to each use. If the
child restraint is loose, repeat steps 4
through 7.
Rear-facing
Follow these steps to install a rear-facing child
restraint using LATCH:
1. If your vehicle is equipped with rear power
seat adjustment, adjust the rear outboard
seats to the upright and rearmost posi-
tion. (See “REAR SEATS” earlier in this
section.)
2. Position the child restraint on the seat.
Always follow the child restraint manufac-
turer’s instructions.
3. Secure the child restraint anchor attach-
ments to the LATCH lower anchors. Check
to make sure the LATCH attachment is
properly attached to the lower anchors.
Front facing — step 7
SSS0638
Rear facing (webbing-mounted) — step 3
SSS0648
1-22
Safety — Seats, seat belts and supplemental restraint system
w
—
—
10/31/07—debbie
X