![background image](/i/infiniti/150598/infiniti-m45-2008-m35-2008/h/infiniti-m45-2008-m35-2008-434.png)
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
Only use the recommended mounting position
or Intelligent Cruise Control (ICC) sensor ob-
struction (if so equipped) may result.
●
License plate bracket
●
J-nut × 2
●
Screw × 2
●
Screw grommet × 2
1. Temporarily place the license plate
bracket while aligning part
s
A
behind the
top of the front bumper opening with part
s
B
of the rear surface of the license plate
bracket.
2. To determine where to drill the hole, mark
along both sides of the mounting hole by
using a felt-tip pen.
3. Remove the license plate bracket and
connect the arcs to form ovals. Mark the
point in the center of each oval. These are
the pilot drilling locations.
STI0560
INSTALLING FRONT LICENSE PLATE
9-14
Technical and consumer information
w
—
—
10/31/07—debbie
X