(       ) to lower it.

    counterclockwise (       ) to raise

38

1. Choose a good location.

    Place your fridge-freezer where it is easy

    to use.
2. Do not place the appliance close to 

    sources of heat, exposed to the direct 

    sunlight or moisture.

4. 

6. Please, do not remove the round stickers 

    on the back side of the refrigerator. 

    They are performing decoration functions

    by closing technological holes.
7. To avoid vibration, the unit must be

    leveled. If required, adjust the leveling 

    screws to compensate unevenness of 

    the floor. The front should be slightly 

    higher than the rear for better door closing.

    The front should be slightly higher than the 

    rear to aid in door closing. To easily turn 

    the leveling screws tilt the appliance 

    slightly. Turn the leveling screws 

    forward part of a refrigerator, clockwise

8. Before using the appliance clean it 

    thoroughly.

9. Install accessories such as ice cube box, 

    etc., in their proper places. They are 

    packed together to prevent possible 

    damage during transportation.

10. Connect the power supply cord (or plug) 

    to the outlet. Don't plug in with other 

    appliances on the same outlet.

Installation

When the appliance is installed let it 

operate for 2-3 hours at normal temperature 

setting before filling it with fresh or frozen 

food.  After unplugging the appliance, wait 

for 5 minutes or  longer  before  reconnecting 

the plug.  Your fridge-freezer is now ready for 

use.

Starting

The appliance is designed to operate at 

the limited range of ambient temperature, 

depending on climate zones. Do not use 

the appliance at the temperature out of the

limit. Climate class of your appliance is 

indicated on the label with technical 

description inside the fridge compartment.

Climate class

Class

Ambient temperature 

range °C

+10 to +32 

+16 to +43 

+16 to +38

+16 to +32

SN

N

T

ST

Symbol

Extended 

temperate

Temperate 

Subtropical 

Tropical

To provide necessary of air circulation, you 

should leave enough space behind, on each 

side and top of refrigerator-freezer. Set the 

limit stops in the upper corners of the back 

plate of the device as shown in picture 1. 

Stops are delivered in the basket door inside 

the refrigeration cabinet.

5.  To provide optimal heat exchange and the 

reduction of power consumption, it is 

recommended to keep the gap from the top, 

between the rear and side walls of the device 

and room walls not less than 5 cm.(picture 2)

3. Make sure that the power supply voltage and 

    type of current which are specified in the 

    instruction are according to the settings in 

    your power supply.  

INSTALLATION

Downloaded from Fridge-Manual.com Manuals