![background image](/i/line-6/138002/line-6-stagesource-l2t-stagesource-l2m/h/line-6-stagesource-l2t-stagesource-l2m-013.png)
S
uSpending
the
L2
t / L2m
The L2t and L2m provide four threaded M10 attachment points for
suspension and one threaded M10 attachment point for pull-back and
aiming the speaker. These are designed to allow for suspending the
loudspeaker only by a qualified professional familiar with safe rigging
practices. Improper installation may result in damage to the speaker or
support structure, or injury or death.
WARNING!
If you are unfamiliar with suspending loudspeakers, con-
sult an authorized, qualified professional prior to installation.
WARNING!
Before rigging or suspending any loudspeaker product, in-
spect all rigging hardware, cabinets, attachment points, transducers, and
associated peripherals. Any absent, warped, or non-load rated equipment
could seriously compromise the strength of the installation and should be
immediately corrected.
WARNING!
Always follow all municipal building codes, as well as any
local, state, and federal safety guidelines regarding the installation and
operation of loudspeakers and associated peripherals.
Always use two attachment points on either the top or bottom of the
L2t/L2m. The rear panel pull-back attachment point is only for aiming
the speaker downwards; it is not to be used as a load-bearing suspension
point. Furthermore, suspension points are for hanging the speaker only;
do not suspend additional speakers or other items from suspension points.
For permanent installations, use only the Line 6 eyebolt kit (part no.
98-037-0005).
Suspension Points
Pull-back
Attachment
BOTTOM
TOP
REAR PANEL