Инструкция для Line 6 XD-V35L, XD-V30, XD-V35

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image

 

Important Safety Instructions

WARNING

 : 

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. 

NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

WARNING

 : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE

APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC 

SHOCK DO NOT OPEN

CERTIFICATION

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE 
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, 
AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFER-
ENCE THAT MAY CAUSE UNDESIRED OPERATION.

Warning: 

Changes or modifications not expressly approved in writing by Line 6 may void the users authority to 

operate this equipment.

RF Exposure Statement: 

This transmitter must not be co-located or operated in conjunction with any other 

antenna or transmitter.

Note: 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if 
not installed and used in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment 
does cause harmful interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003. This Category II radio communication de-
vice complies with Industry Canada Standard RSS-310. Cet appareil numerique de la classe B est conforme a la 
norme NMB-003 du Canada. Ce dispositif de radiocommunication de catégorie II respecte la norme CNR-310 
d’Industrie Canada

The FCC compliance sticker is attached to the THH06 battery compartment.
Remove the THH06 base by unscrewing counter clockwise to see this compliance sticker.

1
2
3
4
5
6
7
8
9
10
11
12
Оглавление инструкции
  • Страница 1 из 13
    ® XD-V35 Digital Wireless Pilot’s Handbook Manuel de pilotage Pilotenhandbuch Pilotenhandboek Manual del Piloto 取扱説明書 40-00-0335 also available @ www.line6.com/manuals Rev C
  • Страница 2 из 13
    Important Safety Instructions C A UT I O N RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
  • Страница 3 из 13
    You should read these Important Safety Instructions. Keep these instructions in a safe place Before using your XD-V35 Digital Wireless System, carefully read the applicable items of these operating instructions and the safety suggestions. 1. Obey all warnings in the XD-V35 manual. 2. Do not perform
  • Страница 4 из 13
    Thank you for your purchase of the XD-V35 wireless microphone system. It is a high quality digital wireless system, in a simple format that is virtually plug-and-play. With its fully digital transmission, the system provides features and benefits that differ in some ways from previous generations
  • Страница 5 из 13
    XD-V35 Digital Wireless Quick Setup Receiver 1 2 3 trans status 4 5 audio 2.4GHz DIGITAL WIRELESS SYSTEM XDpower CHANNEL UNBALANCED OUT BAL OUT RXT06 RECEIVER + 9Vdc 200mA 6 7 8 1. 6-Position Channel Select Knob 2. Battery Level Indicator LEDs – Lights green, with all lit indicating full
  • Страница 6 из 13
    Bodypack Transmitter 3 1 2 6 4 5 1. Audio LED – Green when audio signal present 2. Battery Level LED – Blue with good level, red when low, flashing red when less than 40 minutes remain 3. On / Off Slide Switch 4. Channel Select Slide Switch 5. Quarter-Inch (1/4”) TRS Input Connector 6. Battery Door
  • Страница 7 из 13
    SELECT CHANNEL Handheld Transmitter AA BATTERY 1. Power Button – Press briefly to turn on; press and hold for two seconds to turn off 2. Channel Select Button – Channels 1 – 6 3. Channel LEDs – Lights blue to show current active transmission channel; Channel 6 LED illuminates red when battery life
  • Страница 8 из 13
    the receiver has no gain or attenuation controls. Do not use TRS connectors with the XDV35 Receiver as the Ring portion of the connector is used for firmware updates and may cause computer generated noise in your audio outputs. Note: When the associated transmitter is off, and moderate to strong
  • Страница 9 из 13
    Status LEDs will light green, and when you speak in the mic the receiver Audio LED will light green. Connecting the XD-V35 Receiver The receiver features a balanced XLR and unbalanced (tip-sleeve) quarter-inch connector. To connect to a mixing board or powered mixer, use a microphone cable between
  • Страница 10 из 13
    APPENDICES Troubleshooting Problem Solution No Audio Transmitter off or battery out of power Batteries put into transmitter out of polarity Transmitter and receiver on different channels Receiver off / unplugged or not connected Can’t Turn Off Transmitter Change Channels Transmitter in locked mode
  • Страница 11 из 13
    XD-V35 Digital Wireless System Specifications System Frequency Band 2.4GHz ISM Band Compatible Channels 6 Spatial Diversity with Digital Buffering Yes Frequency Diversity Yes (2 Frequencies per channel) Compander-Free Design Yes Frequency Response THD % 10 Hz (-0.5 dB) - 20kHz (-2.5 dB) 0.03%
  • Страница 12 из 13
  • Страница 13 из 13