![background image](/i/loewe/152575/loewe-connect-id-55-connect-id-46-connect-id-40/h/loewe-connect-id-55-connect-id-46-connect-id-40-005.png)
Connect ID 40-55
- 5 -
Quick guide
english
For your safety
TV sets with 3D function
Read the following safety instructions before using the 3D function
of your TV set.
Please use the Loewe 3D TV sets only with the Loewe 3D glasses which
can be purchased as an accessory from your Loewe dealer.
People with a visual disorder may not be able to perceive 3D effects
or may only be able to perceive them to a limited extent. People who
are sensitive to flickering images (e.g. those with epilepsy) should only
use the 3D function after having consulted their doctor.
It might take some time for you to get used to the 3D glasses and
before you can perceive the 3D effects properly.
Stop using the 3D function immediately if you experience any feelings
of nausea, dizziness or malaise when viewing 3D content.
Supervise children whilst they are viewing 3D content, as they can be
particularly sensitive to it.
Allow more time for a break after having watched 3D movies, so that
you are able to relax. Failure to do so could result in headaches, fatigue,
dizziness or malaise.
Position yourself comfortably in front of the 3D TV set and ensure that
you are seated firmly. By doing this, you will avoid any injuries that may
occur due to reacting to extreme 3D content.
Switch off any artificial light sources (e.g., energy saving lamp) between
the TV set and the 3D glasses. These could impair the infrared recep-
tion or the TV picture may flicker as a result.
Supervision
Do not let
children
operate the TV set unsupervised and do not let
them loiter and play close to the set. The set could tip over, be pushed
off or pulled down from the stand surface and injure someone.
Do not allow the switched-on TV set to run
unattended
.
Volume
Loud music can lead to ear damage. Avoid extreme volume espe-
cially over long periods and when using headphones.
Thunder storms
Pull out the
mains plug
and all connected
antenna cables
from the
TV set in a thunderstorm. Overvoltage caused by
lightning strokes
can damage the set via the antenna system, as well as via the mains.
The mains plug and all connected antenna cables should also be pulled
out during long periods of
absence
.
Automatic shutdown
If the TV is not operated for 4 hours (adjustment of volume, pro-
gramme change, etc.) the TV will automatically switch to stand-by
mode to save energy. A prompt to terminate this shutdown process
appears one minute before expiry of the 4 hours.
The automatic shutdown is generally active for the TV mode as soon
as the energy efficiency mode
Home Mode
is enabled for at least one
of the signal input groups. This also applies if another energy efficiency
mode is selected during initial installation, but one of the signal input
groups is subsequently set to
Home Mode
.
Automatic shutdown does
not
occur when using the radio
without
screen display (
screen off
).
Cleaning and care
Switch off the TV set with the main switch prior to cleaning.
Clean the TV set, the screen, and the remote control unit with a soft,
moist, clean and colour-neutral cloth only,
without
any
aggressive
or
scouring cleaning agents
.
The
speaker panel
of your TV set is covered with textile. Vacuum the
surface regularly using a soft brush set.
In case of
dirt
or
stains
:
Moisten a soft, colour-neutral cloth with detergent or normal stain
remover and gently rub away the stain. You can also treat the mark/
stain directly with normal dry stain remover spray (vacuum up pow-
der).
Do not moisten the covering fabric directly with detergent or stain
remover (risk of encrustation). Do not use any solvents to clean the
fabric.
Follow the manufacturer’s instructions when using stain removers.
There is an increased risk of encrustation when cleaning speaker
panels with nicotine deposits.
Repairs and accessories
Never remove the back of the TV set yourself. Have your TV set re-
paired or serviced by
authorised television technicians
only.
Only use
original accessories
such as Loewe stands, if possible.
Technical information (Connect ID DR+)
Switching off the TV set with the mains switch during operation or an
inadvertent disruption to the power supply (e.g., power failure) can
cause damage to the hard disk file system and hence loss of the re-
corded broadcasts.
Always
return the TV set to Standby mode before
switching it off with the main switch. Never ever disconnect the USB
storage device from the TV set during a copy process.
However, if unexpected problems occur when operating the hard disk,
formatting the hard disk may rectify this. You can find the correspond-
ing menu items under
System settings
ט
Control
ט
more ...
ט
Hard disks
.
Loewe are not liable for the loss of data on the integrated hard disk
of your TV set. To avoid data loss, we recommend copying important
recordings to an external storage medium.