Мануал: Телевизор / 3D очки Loewe Digital TV retrofit kit 2 T-CI

Инструкция для Loewe Digital TV retrofit kit 2 T-CI

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

233-31789.001

Digital TV retrofit kit 2 T-CI

■

Accessories.

Operating instructions.

31789_001 DVB_T_V3_GB

13.11.2003, 15:27 Uhr

Оглавление инструкции

Страница 1 из 15
Operating instructions. Digital TV retrofit kit 2 T-CI Accessories. 233-31789.001 ■ 1 31789_001 DVB_T_V3_GB 1 13.11.2003, 15:27 Uhr
Страница 2 из 15
Contents Welcome 3 General information 3 Connecting antenna 4 Determining antenna position/aligning the antenna 4 Connections on rear of unit Manufactured under license from Dolby Laboratories. „Dolby“ and the double-D symbol are trademarks of Dolby Laboratories. Confidential unpublished works. ©
Страница 3 из 15
Welcome Thank you General information for and congratulations on choosing the Loewe Digital-TV upgrade kit 2 T-CI. Range of stations This integrated digital receiver module with two slots for Common-Interface modules (CI) enable you to receive a number of free digital and coded TV stations which
Страница 4 из 15
Connecting antenna Connect the antenna cable from the roof antenna to the antenna socket ”VHF/UHF IN” on the back of your TV set to receive digitally broadcast programs. Determining antenna position and aligning the antenna An indoor antenna can also be used under good reception conditions. Passive
Страница 5 из 15
Connections on rear of unit Signal Box Spheros 42 HD C R Y SAT Antenna socket terrestrial (DVB-T) CR/ PR UHF/VHF CB/ PB COMPONENT IN AV 1 PIP UHF/VHF L AUDIO IN 3 R R L L AUDIO IN 1 AV 3 AV 2 (RGB) (RGB/YUV) S U R SUB DIGITAL RC5/ IR- AUDIO IN 2 SYSTEM VGA TV set DIG IN 1 RC5/RC6 SERVICE IR COMMON
Страница 6 из 15
Connections on rear of unit Articos 55 Slots for Common Interface modules Digital sound output 1 C R S U R DIG OUT COMMON INTERFACE DIGITAL-TV SUB CRTL L DVI IN VHF/UHF COMPONENT IN COM DIGITAL-TV OUT AUDIO IN 3 R L Y PIP VHF/UHF AV 1 AV 2 (RGB) Connect antenna/ cable system (analog) This
Страница 7 из 15
Initial start-up Preparing for initial installation Pressing the M button returns you to ”Settings”. • Make sure an antenna for the VHF/UHF range is connected to the ”IN VHF/UHF” antenna socket. With this antenna you can receive both digital and analog stations providing they are broadcasted in
Страница 8 из 15
Initial start-up Inserting the CommonInterface module 1. Switch off your TV set with the On-Off switch on the TV. 2. First push the Smartcard into the CI module as far as possible. The side with the golden contact chip neeeds to face the side of the module printed with the provider’s logo. Printed
Страница 9 из 15
Initial start-up Digital radio stations search and store Your receiver can receive and play radio programs in high quality as well as TV programs. Note: Digital radio programs are not broadcasted in the DVB-T standard in all regions at present. Radio stations are stored in a separate station table.
Страница 10 из 15
Daily handling Changing stations with the station table The station table shows the currently stored stations in numerical order: Channel overview: TV AVS AV3 AV2 AV1 0 1 EURONEWS 2 EURONEWS D D 3 TVC INT. D 4 ANDALUC D 5 CANAL CA D 6 ETB SAT Numerical 7 RADIO 8 RADIOS E 9 TM SAT/L 10 CNN INT. 11
Страница 11 из 15
Daily handling Notes: Picture in picture (PIP) • Selection menus are only available as long as the status bar is displayed. However, you can call it again at any time by pressing the E button on your remote control. You can watch two analog or one digital and one analog program on your screen at
Страница 12 из 15
What to do when... Malfunctions, their causes and remedies Problem Possible cause and remedy No reception with active antenna Activate the supply voltage, see page 4 chapter ”Connecting antennae”. Picture and sound interference (block formation) Optimize the position or alignment of the reception
Страница 13 из 15
Problem Possible cause and remedy No coded programs are shown in the station table although the CI module and the Smartcard of the provider are used. CI module and/or Smartcard are possibly not inserted correctly (see the section ”Connection and initial start-up”). You can check whether the module
Страница 14 из 15
Index CI module (Common Interface) EPG A CI module is a decoder module for digital TV and radio programs according to the CI standard. Electronic Program Guide: your TV“s electronic program guide To show the coded programs a released Smartcard of the program provider is required in addition to a CI
Страница 15 из 15

Инструкция для Loewe Digital TV retrofit kit 2 T-CI

Инструкции и руководства похожие на Loewe Digital TV retrofit kit 2 T-CI

Другие инструкции и руководства из категории Телевизор / 3D очки