7

• If you change the CI module or insert an

additional one later, you have to run a
new station search so that the stations of
the new provider can be found and stored.

• Which of the programs of the provider you

can watch in the end depends on which
program package you have bought.

• To extend an existing station list we

recommend you to activate the option
search and store ”new stations only”.

10. Start the station search with 

OK

.

The station search may take some time.

Do not make any entries or switch off
the set during this time.

When the search has ended you will be
shown the found and stored stations sorted in
numerical order.

If you also want to search for and store
analog programs, press the 

M

 button. Repeat

the steps 5 to 10.
Select ”

Analog

” in step 5 and the

transmission standard, e.g. ”

Autom.–BG

”.

After the station search has been completed,
hide the table by pressing the 

E

 button.

Station sorting

You can change the automatic station sorting
later at any time as you like.

Preparing for initial
installation

• Make sure an antenna for the VHF/UHF

range is connected to the ”IN VHF/UHF”
antenna socket.
With this antenna you can receive both
digital and analog stations providing they
are broadcasted in your area.
The antenna bridging cable must also then
be plugged for analog stations.

• If your TV has been upgraded later with the

”Digital-TV upgrade kit 2 T-CI” we
recommend you to perform the ”

Programs

–Automatic Search

” function. You can

search for and store analog and digital
(DVB-T) programs.

Note:
The function ”Repeat initial start-up” deletes
any stored programs and personal settings.

• If you also want to receive coded stations,

the Common-Interface module (CI module)
and the appropriate Smartcard must be
inserted in the slot of the TV set, see the
chapter ”Inserting the Common-Interface
module”.

Automatic station search
and store

1. Switch on your TV and

if no menu is displayed, call the ”TV-menu”
by pressing the 

M

 button on the remote

control

2. Select the ”Settings” item and confirm with

OK

.

Note:
If you use an active terrestrial antenna, this
requires a supply voltage (5 Volt). In this case
select the ”Terrestrial Antenna” line in the ”TV
menu”. Press the OK button and then select
”yes (5 V)”.

Pressing the 

M

 button returns you to

”Settings”.

3. Select the ”Channels” line and confirm with

OK

.

4. Select ”Automatic search” and confirm with

OK

.

You get a table for the automatic program
search.

5. Select ”Change search settings” and

confirm with 

OK

. Follow the menus.

Initial start-up

Change search settings

Channels

Mark,
select and
press OK to proceed

Please define the scope of channels to search for:

Search 

OK

M

i

E

Back

Info

End

Type of signal

Analog       DVB-T

Channel search

all

6. Specify whether you want to search for

digital (DVB-T) or analog stations.
In DVB-T you can select a channel search
(fast station search) or a frequency search.
In addition you can have all stations or only
new ones searched for.

7. Confirm your selection with 

OK

.

8. Specify from which program place the

stations are to be stored and confirm with

OK

.

9. Select „Start search“.

Notes:
• The frequency search option is to be

preferred only in exceptional cases such as
in the event of deviations from the
standardized channels.

• If you have purchased a CI module, please

insert it before you start the search because
only then will the provider’s coded
programs be recognized and stored. You can
insert and use two CI modules in the two
slots simultaneously.

31789_001 DVB_T_V3_GB

13.11.2003, 15:27 Uhr

7