8

New CI module plugged

After plugging a new CI module and switching
on the TV set, the following dialog box
appears:

Autom. channel search

Press OK to proceed

OK

E End

Your TV set has detected a new CI module. 
This requires a program search for all 
new receivable programs.

After pressing the 

OK

 button, the wizard for

the automatic station search is started. Please
check the suggested search parameters there.
Continue with the section ”Automatic station
search” on page 7.

Default for DVB subtitles

If the station provider offers DVB subtitles, you
can have these displayed permanently or
suppress the display. You can also choose
between ”Translation” or subtitles for the
persons with hearing impediments.
1. Call the ”TV-menu” with the 

M

 button.

2. Select the ”Settings” line and confirm with

OK

.

3. Select the line ”DVD subtitles” and confirm

with 

OK

.

DVB subtitles

Subtitles off

OK

M

i

E

Back

Info

End

for translation

for impaired hearing

If you select ”Subtitles off” there is only a
display in the status bar. See page 11 for
showing subtitles again.

COMMON INT

ERF

A

C

E

COM DIGIT

AL-TV

Eject button

CI module

COMMON INTERFACE

CI module

Signal Box

Initial start-up

Inserting the Common-
Interface module

In order to receive encrypted channels, the
Common-Interface module (CI module) for
the Smartcard has to be inserted in the
appropriate slot of your TV. If this is not
already the case, you have to insert it. You
will find the slots on the back of your Loewe-
TV-set or on the front of the signal box (in
Spheros 42 HD).

1. Switch off your TV set with the On-Off

switch on the TV.

2. First push the Smartcard into the CI module

as far as possible. The side with the golden
contact chip neeeds to face the side of the
module printed with the provider’s logo.
Printed arrows show you how to insert the
card.

Please also observe the installation
instructions enclosed with the Smartcard.

3. Push the CI module carefully, contact side

first, into one of the two slots labeled
”Common Interface”. The side printed with
the provider’s logo must face left or up.

Make sure the module is not inserted skew.
Do not use force. The eject button is pressed
out when the module snaps in.

Removing the CI module

You can remove your Common-Interface
module to receive encrypted channels on
another TV set.

1. Switch off your TV at the power switch.

2. Press in the eject button on the slide-in

module, the module jumps out.

3. Pull the module out of the set.

31789_001 DVB_T_V3_GB

13.11.2003, 15:27 Uhr

8