![background image](/i/loewe/156708/loewe-speaker-2go/h/loewe-speaker-2go-022.png)
Speaker 2go
- 22 -
Operating instructions
English
Start-up
Charging the built-in battery
The battery in the device is already installed ex factory. Before the first use, the battery must be
charged for about 3 hrs. With a fully charged battery the Speaker 2go is operational for about
8 hrs.
Insert the plug (
S
) into the socket
12
at the rear side of the Speaker 2go.
Then plug the power adaptor (
N
) into a 110-240V 50/60Hz mains socket.
The battery charge level is shown by the LED indicator
2
.
LED pulsing red:
Device standby, charging battery
LED pulsing white:
Device standby, battery fully charged
LED lights up white:
Device switched on
Switching on
Set the slide switch
11
to the
ON
position.
Turn on the Speaker 2go using the key
1
. The LED indicator
2
lights up.
During battery operation the battery capacity level is shown by the LED.
Battery capacity more than 25%:
LED lights up white.
Battery capacity 11% to 25%:
LED lights up red.
Battery capacity 5% to 10%:
LED blinking red.
Battery capacity is below 5%:
Speaker 2go switches off (safety buffer).
Switching off
Switch the Speaker 2go to the standby mode using the key
1
.
The LED indicator
2
goes off.
After 10 minutes without audio playback or key operation, the Speaker 2go
automatically switches to standby mode.
When the speaker is not used for a longer time and before a transport, set the
sliding switch
11
to the
OFF
position.
S
12
14
13
11
N
ON/OFF
ON/OFF