Test Result 4: 

Wiring diagram (WIREMAP) display

when there is an open circuit at the far-end of cable.

Wire map:fail

R: 12 x45 x78  id1

Iiiiiiii 

M: 12345678 

"

R:" line "3" and "6" pins location display "x", it indicates an open circuit 

infar-end plug "3" and "6" pins and the open circuit is located nearby the 
far-end plug.(The open point  should be at the 10% cable length)
Note: 

the detected cable is made of  paired  cable cores, “open” 

error at the far-end always displays in pair as  above.,which means there 
is one open circuit or both 

because 

are open in the far-end"3"and "6"pins. 

Test Result 5:

 Wiring diagram (WIREMAP) display when 

there is an open circuit at the near-end of cable. 

It will display wiring diagram (WIREMAP) as follows if there is an open 
circuit at the near-end plug of the cable:

Wire map:fail

R: 12345678  id1

Iiiiiiii 

M: 12 x45678 

"

M:" line "3" pin location displays "x", it indicates an open circuit at 

near-end plug "3" pin and the open circuit is located nearby the near-
end plug.(The open circuit should be located within 10% cable length 
if it is measured from the near-end plug)

Test Result 6:

Wiring diagram (WIREMAP) display when 

there is an open circuit in the middle of the cable.

It will display wiring diagram (WIREMAP) as follows if there is an 
opencircuit in the middle of the cable:

Wire map:fail

R: 12345678  id1

Iixiiiii 

M: 12345678 

"|" line "3" pin location displays "x", it indicates an open circuit in the 
middle of "3" pin cable. (The open circuit should be located within 
10%-90%  cable length if it is measured from the near-end plug.) as 
detailed hereinafter.

Your excellent helper in cable test!

07