Short
12

   Continue? 

No          yes 

At the moment, push     key (No) to exit calibration function. Push     key 

(Yes) to repeat the measurement.

Note:

The calibration  will recover the standard value of Class UTP5 

cable at  factory.

Start up or shut down AF hunting function

(1). Press PUSH key,the hunting indicator light (SCAN) flashes,which indicates 

that audio frequency transmission of main tester is norma l , insert the cable to 

be tested into RJ45 SCAN Port . then hold the receiver to trace cable needed 

(the usage of receiver is shown in the following). RJ11/BNC/ USB cable is 

located when inserted into its corresponding port. 

(2).The user can turn volume switch to control the volume.

(3).The floodlight function  helps  the users operate in dark environment. 

(4).Earphone  helps avoid  external  interference in noisy environment.

(5).The test can not measure cable length and wire faults when it is 

      operated to trace cable.

Usage of the receiver 

Install 9V battery ,press “PUSH” key, then approach the cable with probe 

and find targeted one  among lots of cables. When the probe is near target 

wire, the “beep, beep and beep” sound will  come out and the signal indicator 

light “POWER” will be bright.  When loudest “beep” and brightest indicator 

means  that is the  required cable.

If there is short circuit in cable, It will display as follows.

Your excellent helper in cable test!

11