Test Result 4: 

Wiring diagram (WIREMAP) display

when there is an open circuit at the far-end of cable.

Wire map:fail

R: 12 x45 x78  id1

Iiiiiiii 

M: 12345678 

"

R:" line "3" and "6" pin location display "x", it indicates an open circuit in

far-end plug "3" and "6” pin and the open circuit is located nearby the far-end 
plug.(The open circuit should be located within 10% cable length if it is 
measured from the far-end plug)
Note: because the cable is made via paired cable cores,the open circuit at the 
far-end always displays in pair as shown above where there is one open circuit 
or all are open circuits in the far-end "3"and "6"pins. For identification, it is 
simple to move the tester to the far-end to have the measurement.

Test Result 5:

Wiring diagram (WIREMAP) display when there is an open 

circuit at the near-end of cable.It will display wiring diagram(WIREMAP) as 
follows if there is an open circuit at the near-end plug of the cable:

Wire map:fail

R: 12345678  id1

Iiiiiiii 

M: 12 x45678 

"M:" line "3" pin location displays "x", it indicates an open circuit at near-end 
plug "3" pin and the open circuit is located nearby the near-end plug. (The 
open circuit should be located within 10% cable length if it is measured from 
the near-end plug)

Test Result 6: 

Wiring diagram (WIREMAP) display when there is an 

open circuit in the middle of the cable.

Wire map:fail

R: 12345678  id1

Iixiiiii 

M: 12345678 

"|” line "3" pin location displays "x", it indicates an open circuit in the middle of 
"3" pin cable. (The open circuit should be located within 10%-90%cable length 
if it is measured from the near-end plug.) The pair and length function (PAIR 
& LENGTH) can make user know where the open point accurately is.

Your excellent helper in cable test!

07