rod with the basket into its housing, and press 

until it clicks into place.

 11•   Attach the basket in the front by slipping the 

buttonholes over the hooks under the footboard.  

To fasten the side of the basket, lower the basket 

rod and slip the buttonholes over the hooks, as 

shown in the figure.  

   POUCH

 12•   The pouch that comes with the stroller attaches 

to the handle. Place the pouch as shown in the 

figure and press it downwards, all the way into the 

housing on the handle. (Repeat on the other side). 

 13•   The pouch can be worn as an accessory, using the 

special belt.

   HOOD

 14•   To attach the hood, insert the fasteners into the 

special housings, as shown in the figure.

 15•   Button the hood to the back of the backrest and 

the inside of the armrests, as shown in the figure.

 16•   Lower the braces to stretch the hood.

 17•   The hood reclines along with the backrest. When 

you lift the moveable part of the hood, you will 

find a net insert that will provide better ventilation 

for the baby, while allowing you to see him from 

any position.

 18•   The hood can easily be turned into a sun canopy, 

as shown in the figure.

 19•   To remove the hood, fold the braces, unbutton 

the hood, and press the button as shown in the 

figure while slipping the hood fastener out of its 

housing. (Repeat on the other side).

   COVER

 20•   Fasten the cover by zipping it to the footboard, as 

shown in the figure.

   RAIN CANOPY

 21•   To mount the rain canopy, fasten the zipper on 

the canopy to the zipper on the hood, and button 

the sides to the hood.

 22•   Slip the rain canopy elastic over the bottom of the 

front frame and button it as shown in the figure.

 23•   The practical rain canopy can be lowered by 

opening the zipper and leaving the canopy 

buttoned to the stroller.

 24•   This rain canopy has also been designed for use 

with the Primo Viaggio child car seat attached to 

the stroller, to guarantee total protection for your 

child.

 • 

 Do not use the rain canopy in closed areas. Always 

check to make sure that the child is not too hot.

 • 

 Do not place the PVC rain canopy near heat 

sources. Be careful with cigarettes when near the 

rain canopy.

 • 

 Make sure that the rain canopy does not become 

entangled in any moving mechanism on the 

stroller or chassis.

 • 

 Always remove the rain canopy before closing the 

chassis or the stroller.

 • 

 Wash using a sponge and soapy water; do not use 

detergents.

   BRAKE

 25•   To brake the stroller while moving, pull the handle 

on the handlebar towards you.  To set the parking 

brake, use the lever as shown in the figure.Always 

set the brake when the stroller is not moving.

   SAFETY BELT

 26•   A: Make sure that the brace is properly inserted by 

pushing as shown in the figure. B: Fasten the belt 

as shown in the figure.

 27•   To unfasten the belt, press on the buckle sides 

and pull out the waist strap.

 28•   The new safety belt is now easier to fasten thanks 

to the "snap-open-and-shut" device. Before 

fastening the safety belt, attach the buckle to the 

backrest by inserting the tab through the special 

holder, as shown in the figure. After fastening 

the safety belt on your child, detach it from the 

backrest to allow the child more freedom of 

movement. The buckle must remain below the 

child's shoulders.

   BACKREST ADJUSTMENT

 29•   The backrest of the stroller can be reclined in 

several positions. To lower the backrest, lift the 

handle as you recline the backrest, locking it at 

the desired height. To raise it, push the backrest 

up.

   ADJUSTING THE FOOTREST

 30•   The footrest can be adjusted to two positions. 

To lower it, pull the two levers downwards while 

lowering the footrest, as shown in the figure.  To 

raise the footrest, lift it upwards until it clicks into 

place.

   SWIVEL OR STATIONARY FRONT WHEEL

31•   To set the front wheel on stationary, turn the knob 

counterclockwise (picture of padlock closed).

32•   To swivel the front wheel, turn the knob clockwise 

(padlock open).

   AIR PUMP

33•   To inflate the tires, use the pump located under 

the seat.  Slip the hose off the pump as shown in 

figure A and screw it onto the opposite end of the 

pump (Fig. B).

34•   Remove the cap from the tire (Fig. A) and fasten 

the end of the hose to the tire as shown in figure 

B.

 • 

 Before using the stroller for the first time you are 

advised to inflate the tires to a pressure of 25 

P.S.I./1.7 bar.

   SHOCK ABSORBERS

 35•   All of the wheels are equipped with shock 

absorbers. The rear wheels have adjustable 

shocks; you can choose from “HARD” for soft 

terrain such as sand and lawns, “SOFT” for rough 

surfaces such as gravel and cobble stones, and 

“MEDIUM” for smooth, firm surfaces. To adjust 

the shocks on the rear wheels, turn the knob 

to choose one of the three settings. We advise 

adjusting both rear wheels to the same setting.

   LEVERAGE BOARD

 36•   The rear leverage board helps the mother push 

the stroller over slightly uneven ground. 

   FRONT BAR

 37•   The practical front bar opens and closes to make 

it easier for the child to get in and out of the 

stroller when he is older. To open the bar, press 

the front bar button, which is located under the 

armrest. Pull the bar outwards at the same time. 

To close the front bar, carry out the instructions in 

reverse order. 

 38•   To remove the front bar, press both front bar 

buttons under the armrest, while pulling the front 

bar outwards.

 39•   The front bar is also extendible. To extend the 

front bar, press the long button located under the 

armrest and pull the front bar outwards. (Repeat 

on the other side). 

 40•   To shorten the front bar, press the long button 

and push the front bar into the armrest. (Repeat 

on the other side.)

   SIDE DRINK HOLDERS

 41•   The stroller is equipped with two side drink 

holders that fold away or pull out as necessary. To 

pull the drink holders out, lift the upper part and