10
EN
Caution
•
To avoid any accident, the driver must not watch video
while driving. This unit is designed to not allow watching
moving video while driving. Park your car in a safe place and
engage the parking brake before watching moving video.
Note
•
The video blocking system under parking brake not
engaged only control the display of this unit, and will
not affect the video output through the rear RCA
video output.
•
If watch moving video from disc or AV-IN source but
parking brake is not properly connected, the video
signal will be blocked by the system, and the below
display will be shown on TFT:
1
2
3
4
5
6
7
8
9 0 ! "
$
&
§
%
18
19
/
20
21
22
Connector/Object
Connect to/with
1
Pink wire
Extension wire
2
Extension wire (not
included)
Parking brake (-)
3
Brake switch
4
Ground
5
Purple wire
Reverse camera (B+)
6
Gearbox switch
7
Reverse gear signal
Black lamp lead +
8
ISO wires
Connected in step 1 above
9
Yellow cable
Video out
10 Red cable
Rear line out (Right)
11 White cable
Rear line out (Left)
12 Red cable
Front line out (Right)
13 White cable
Front line out (Left)
14 Red cable
Audio in (Right)
15 White cable
Audio in (Left)
16 Yellow cable
Video in
17 Brown cable
Camera in
18 Blue cable
Subwoofer
19 White wire
OE remote
20 Black wire
Radio antenna
21 Black wire
External microphone
22 Black wire
GPS smart antenna
Mount into the dashboard
Note
•
Check wire connection before you mount the unit
into a car.
•
If preset radio stations are lost when the ignition key is
turned off and then turned on, reconnect the red leads
crosswise to the yellow ones.
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative terminal
of the car battery.
•
If you disconnect the car battery in a car that has
an on-board drive or navigation computer, the
computer may lose its memory.
•
If the car battery is not disconnected, to avoid
short-circuit, ensure that the bare wires do not
touch each other.
2
Ensure that car dashboard opening is within these
measurements:
