•
Plug the RCA connectors of the 2RCA to 3.5 mm mini-jack stereo signal cable (included) into the
AUDIO IN LEFT/RIGHT input, and the 3.5 mm mini-jack of the signal cable – into the output of your
PC sound card or an audio output of another sound source, as shown in Fig. 2.
Notes:
• To connect the MSS to a CD/DVD/MP3 player or TV, use the 2RCA to 3.5 mm mini-jack
stereo signal cable (included) with a mini-jack to 2RCA adapter (not included) or a 2RCA to
2RCA stereo signal cable (not included), as shown in Fig. 2.
• To connect a subwoofer to the MSS, plug the signal cable supplied with the subwoofer
into SUB.OUT on the rear panel of the active speaker (see Fig. 2).
•
Plug the power cord into a mains outlet. Set the master volume level to the minimum by turning
the VOLUME control knob
a
counterclockwise until it stops.
•
Switch on power supply by turning the POWER knob
d
on the active speaker side panel clock-
wise until it clicks.
•
Turn on your audio source.
•
Adjust the volume level by turning the VOLUME control knob
a
. By turning the knob clockwise,
you increase volume level; by turning the knob counterclockwise, you reduce it.
•
Adjust the treble and bass levels by turning the TREBLE control knob
b
and BASS control knob
c
respectively. By turning the knobs clockwise, you increase the treble/bass level; by turning the
knobs counterclockwise, you reduce it.
Notes:
• After using the MSS, mind to switch it off on the active speaker side panel by turning the
POWER knob
d
counterclockwise until it clicks, and unplug the power cord.
• To enhance the sound quality, use the Line-Out output of the sound card.
If none of the above methods can solve the problem, please seek professional advice at your
nearest service center. Never attempt to repair the product yourself.
Problem
The MSS does not
turn on.
No sound.
There is too quiet
sound of speakers.
Distortion of
sound.
Cause
The MSS isn’t connected to a mains outlet.
The power switch is o
Ԛ
.
The volume level is set at minimum value.
Improperly connected audio source.
The volume level is set at minimum value.
Large amplitude of the input signal.
Solution
Check the connection.
Turn on the switch.
Adjust the volume control knob.
Connect audio sources correctly.
Adjust the volume control knob.
Turn down the source volume
and MSS volume.
6. TROUBLESHOOTING
16
ENG
2.0 Multimedia Speaker System
