CARB
CARBURETOR
5-5
NOTE:
The arm of the float should be supported on
the valve without compressing it.
• If the height of the float is not within the spe-
cified limits, inspect the valve and its seat.
• Substitute both parts if any part of them is
worn.
• If both are in good condition, replace the
float.
• Check the height of the float again.
NOTE:
The height of the float is adjusted in the fac-
tory. Do not try to modify it under any cir-
cumstances.
EAS00487
ASSEMBLING THE CARBURETOR
The assembly of the carburetor is carried out
following the reverse procedure to “DISAS-
SEMBLY”. Bear in mind the following points:
CAUTION:
• Before assembling the carburetor, wash
all of the parts in a petroleum-based sol-
vent.
• Always use new gaskets.
1. Install:
• jet needle
• clip
• throttle valve
• spring seat
• spring
2. Install:
• throttle valve
NOTE:
Align the groove
with the carburetor projec-
tion
.
Jet needle clip position:
3/5 (Dell’orto)
2/3 (Gurtner)
1/3 (Mofa Version)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
