ELEC
IGNITION AND STARTER SYSTEM
7-8
NOTE:
• Remove the following parts before repairing the faults.
1) Side covers (right and left)
2) Rear cover
3) Front mudguard
4) Handlebar cover (upper)
• Use the following special tool for these repairs.
THE STARTER MOTOR DOES NOT FUNCTION
Pocket tester:
90890-03112
1. Fuse
• Remove the fuse.
• Connect the pocket tester (
Ω
x1) on the
fuse.
• Check the fuse to see if there is continuity.
2. Battery
• Check the conditions of the battery.
Consult the “INSPECTION OF THE BAT-
TERY” section in chapter 3.
CONTINUITY
CORRECT
Open circuit voltage:
12.8 V or more at 20 °C (68 °F)
• Check the operation of the starter motor.
3. Starter motor
• Connect the positive terminal of the battery
and the starter motor cable
using a
bridge cable
*
STARTER MOTOR
TURNS
NO CONTINUITY
The fuse is defective
INCORRECT
• Clean the battery terminals
• Recharge or change battery.
STARTER MOTOR DOESN’T TURN
The starter motor is defective, repair or
change.
s
s
WARNING:
• The bridge cable should have the same
capacity as the cable or more, otherwise
the cable may burn .
• This composition may cause sparks, as a
result, ensure that there are no gases or
inflammable liquids in the area.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
