2

GB

! Before operating your new appliance please read
this instruction booklet carefully. It contains
important information concerning the safe installation
and operation of the appliance.
! Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.

! The appliance must be installed by a qualified
professional according to the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the appliance has been
disconnected from the electricity supply.

Positioning and levelling

! It is possible to install the appliance alongside

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall in contact with the back of
the appliance is made from a non-flammable, heat-
resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the bed-

sit (not in the bathroom).

• If the top of the hob is higher than the 

cupboards,

the appliance must be installed at least 200 mm
away from them.

• If the cooker is

installed underneath a wall

cabinet, there must be a
minimum distance of 420

mm between this cabinet

and the top of the hob.

This distance should be

increased to 700 mm if
the wall cabinets are
flammable (

see figure).

• Do not position blinds behind the cooker or less

than 200 mm away from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the
appliance, screw the
adjustable feet* into the
places provided on each
corner of the base of the
cooker (

see figure).

The legs* provided with the
appliance fit into the slots on
the underside of the base of
the cooker.

Electrical connections

Fitting the power supply cable

The cable should be suited to the type of electrical
connection used, according to the following
connection diagram:

To install the power supply cable correctly:

1. Loosen the screw V
in the terminal board
and pull the cover to
open it (

see figure).

2. Position the connection
support A (

see figure)

according to the
connection diagram shown
above. The terminal board
is designed for single-
phase 230 V connection:
terminals 1, 2 and 3 are
connected to each other;
jumper 4-5 is located in the

lower area of the terminal board.
3. Position wires N and 

6

6

6

6

6

 according to the diagram

(

see figure) and perform the connection by

tightening the terminal board screws as much as
possible.
4. Position the remaining wires on terminals 1-2-3
and tighten the screws.

Installation

HOOD

420

Min.

min. 

650

 mm. with hood

min. 

700

 mm. without hood

mm.

600

Min.

mm.

420

Min.

mm.

V

1

2

3

N

A

B

We recommend cleaning the oven before
using it for the first time, following the

instructions provided in the "Care and
maintenance" section.

1

2

3

4

5

1

2

3

4

5

1

2

3

4

5

R

S

T

N

R

S

N

R

N

400 3N 

H05RR-F 5x2.5 CEI-UNEL 35363

400V 2N  

H05RR-F 4x4 CEI-UNEL 35363

230V 

H05RR-F  3x4 CEI-UNEL 35363

H05VV-F  3x4 CEI-UNEL 35746

H05VV-F  4x4 CEI-UNEL 35746

H05VV-F  5x2.5 CEI-UNEL 35746