Installation of gas cookers

•'Before your appliance is 
connected to the gas supply, 
check the ensure that the gas 
category and pressure 
specifications shown in the data 
plate corresponds with your gas 
supply. If necessary call authorized 
service for adjusting to gas 
category.

«•This appliance shall be installed 

in 

accordance 

with 

the 

regulations in force and only used 
in a well ventilated space. Read 

the  instructions  before  installing 
or 

using 

this 

appliances. 

In  the  interest  of  safety  this 
appliances  must  be  installed 
and/or  serviced  by  a  competent 
person as stated in the gas safety 
regulations current editions.

Please refer to the data plate 

for details about gas supply and 

pressures.
c«'  The  appliance  must  not  be 
installed  in  a  room  without  a 

window  or  other  controllable 
opening. If is installed in a room 
without  a  door  which  opens 
directly  to  tohe  outside,  a 

permanent  opening  is  required. 

The  air  circulation  should  be  2 

m3/h per kW of burners.

Connection of the gas hose to the 
oven

Convenient position is selected by interchanging 

the hose nozzle and plug according to the 

location of the main gas inlet valve. If you make 
a connection with a flexible metal hose , locate 
a seal between the main gas pipe. The inner 
diameter of the flexible hose, which the butane 
hose nozzle is connected, should be 6mm for 

the house-type gas tubes.
The inner diameter of the flexible hose, which 
the  natural  hose  nozzle  is  connected,  should 

be 15mm. The hose should tightly be fitted to 

the hose nozzle by squeezing with a clamp.The 

plastic  hose  end  is  soaked  in  hot  water  for 

one  minute  to  soften  and  inserted  fully 

into  the  hose  nozzle.  The  clamp  is  fastened 

securely  by  a  screw  driver.  The  other  end 

of  the  hose  is  connected  to  the  gas  valve 

with the same operation.
The hose should be replaced before its last 
expiry date.

plug 

Hose nozzle

¥

Caution!
Make the oven connection to the 
gas inlet valve, the hose length 
must be short and be sure that 

there is no leakage. The hose used 
should not be longer than 125 cm 
for safety.

Connection of the gas hose 

to the oven

Convenient  position  is  selected  by 
interchanging  the  hose  nozzle  and 
plug  according  to  the  location  of 

the main gas inlet valve. The plastic 

hose end is soaked in hot water for 

one  minute  to  soften  and  inserted 
fully into the hose nozzle. The clamp 

is fastened securely by a screw 
driver.  The  other  end  of  the  hose 
is  connected  to  the  gas  valve  with 

the same operation.

Gas leakage control

During control, be sure that the 

control knobs are closed and the gas 
inlet valve is open. Apply soap bubbles 
to the connections for leakage 
control. In case leakage exists, buble 
will appear. In such case, check the 
gas connection immediately. Do not 
control gas leaks by using fire. 

Caution!

Never use lighter or match 

flame, for controlling the gas 

lackage.

Hose nozzle and elbow types 

for Natural gas and 

Butane/propane