Maintenance

33

Step 1. Turn the power off and disconnect the projector from the wall socket.
Step 2. Turn the projector over. Then loosen the 

screws and remove the lamp cover. If 
the lamp is hot, avoid burns by waiting 
for 45 minutes until the lamp has 
cooled.

Step 3. Loosen the screw that fixing the lamp to 

the projector. If the screw is not loos-
ened completely, they could injure your 
fingers. It is strongly recommended that 
you use a magnetic-head screwdriver.

Step 4.  Lift the handle so that it stands up. Use 

the handle to slowly pull the lamp out 
of the projector.

Pulling it too quickly may cause the lamp to
break and scatter broken glass in the projector.

Do not place the lamp in locations where water
might splash on it, children can reach it, or near
flammable materials.

Do not insert your hands into the projector after the lamp is removed. If you touch the optical
components inside, it could cause color unevenness and distortion of the projected images.

Step 5. Insert a new lamp. Make sure the handle 

is fully locked and tighten the screw 
firmly.

Loose screw may cause a bad connection, which
could result in malfunction.

Do not over tighten the screw.

Step 6. Re-install the lamp cover and tighten the 

screw. Do not turn the power on with 
the lamp cover removed. Whenever the 
lamp is replaced, reset the total lamp 
operation time. Do not reset if the lamp is not replaced as this could cause damage. 

Step 7. Resetting the lamp counter  

i. Press and hold the 

5

 button on the projector for 5 seconds 

to display the total used lamp time.
ii. Press Auto on the projector or on the remote control to 
access the lamp hour timer. An adjustment message will 
appear.
iii. Press 

W

 or 

X

 to reset lamp hours and press Auto to leave.