17

  Setting Up Your Projector

Setting Up Your Projector 

Preparations

1.

Remove the lens cap.

2.

Turn all of the connected quipment on.

3.

Plug the supplied power cord into the AC inlet on the rear of 
this unit. 

4.

Plug the power cord into a wall socket and turn the wall 
switch on.

5.

Turn on the main power switch at the rear of this unit (next to 
the AC inlet). The POWER light will light up in orange. Press 
POWER ON/OFF key on the remote control or POWER key 
on the projector for ONE second to turn the projector on.

Adjust the Height

There are four adjustment screws on the bottom of the projector. These 
adjustment screws change the image height and projection angle. They 
can lift the projection angle by up to 15 degrees. To adjust the projector, 
you can screw the height adjustments to fine-tune the projection angle. 

If the screen and the projector are not perpendicular to each other, the 
projected image becomes vertical trapezoidal. To correct this problem, 
adjust the value of Keystone in the Installation menu. See page 27 for more 
information.