6
Hammer drill
INTENDED USE
This tool is intended for hammer drilling in brick, concrete
and stone as well as for drilling in wood, metal, ceramic
and plastic. Tools with electronic speed control and left/
right rotation are also suitable for screwdriving and thread
cutting
TECHNICAL SPECIFICATIONS
1
PRODUCT ELEMENTS
2
1
On/Off switch with speed control
2
Switch locking button
3
Wheel for maximum speed control
4
Switch for changing direction of rotation
5
Switch for selecting drilling function
6
Auxiliary handle
SAFETY
WARNING! Read all instructions. Failure to follow all in-
structions listed below may result in electric shock,
fi
re
and/or serious injury.
●
Wear ear protectors with hammer drills (exposure to
noise can cause hearing loss)
●
Use auxiliary handles supplied with the tool (loss of con-
trol can cause personal injury)
●
Avoid damage that can be caused by screws, nails and
other elements in your workpiece; remove them before
you start working
●
Always keep the cord away from moving parts of the
tool
●
When you put away the tool, switch off the motor and
ensure that all moving parts have come to a complete
standstill
●
Use completely unrolled and safe extension cords with
a capacity of 16 Amps (UK 13 Amps)
●
In case of electrical or mechanical malfunction, immedi-
ately switch off the tool and disconnect the plug
●
SBM Group can assure
fl
awless functioning of the tool
only when original accessories are used
●
Use only accessories with an allowable speed matching
at least the highest no-load speed of the tool
●
This tool should not be used by people under the age
of 16 years
●
Be careful not to drill or drive into areas where electrical
wires may be contacted
●
If the cord is damaged or cut through while working, do
not touch the cord, but immediately disconnect the plug
●
Never use tool when cord is damaged; have it replaced
by a quali
fi
ed person
●
Always check that the supply voltage is the same as
the voltage indicated on the nameplate of the tool (tools
with a rating of 230V or 240V can also be connected to a
220V supply)
●
If the drill bit becomes unexpectedly jammed (causing
a sudden, dangerous reaction), immediately switch off the
tool
●
Be aware of the forces that occur as a result of jamming
(especially when drilling metals); always hold the tool
fi
rmly with both hands and take a secure stance
●
Always disconnect plug from power source before mak-
ing any adjustment or changing any accessory
●
Holding the tool
- keep the ventilation slots uncovered
- do not apply too much pressure on the tool; let
the tool do the work for you
Your machine is double insulated in accordance
with EN60745; therefore no earthwire is required.
MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor.
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots free
from dust and dirt.If the dirt does not come off use a soft
cloth moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water, etc. These sol-
vents may damage the plastic parts.
The machine requires no additional lubrication.
Should a fault occur, e.g. after wear of a part, please con-
tact your local SBM Group dealer.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of the
packaging materials can be recycled. Take these materi-
als to the appropriate recycling locations. Take your un-
wanted machines to your local SBM Group dealer. Here
they will be disposed of in an environmentally safe way.
English
