22
5.4
u
se
WIth
d
eterGents
WARNING
• The high pressure cleaner was designed to be used with the detergents recommended by the Manufacturer. Use of other
detergents or chemicals can affect the safety of the high pressure cleaner.
Never suck up liquids, which contain solvents, petrol, diluents, acetone and fuel oil, as these products are highly
inflammable, explosive and toxic when nebulized.
• Carefully read the instructions and warnings on the label of the detergent to be used.
• Store detergents in a safe place out of children’s reach.
• Should detergent come into contact with your eyes, wash immediately with water. Contact a doctor without delay
and remember to take the container of detergent with you.
• If detergent is swallowed, do not provoke vomiting. Contact a doctor without delay and remember to take the container
of detergent with you.
• When filling the tank with detergent, take care not to spill any detergent on the high pressure cleaner. If this should
happen, wait at least 24 hours before using the high pressure cleaner so that any liquid, which may have entered the
appliance, can evaporate.
The recommended detergents, are over 90% biodegradable.
• Remove the plug (31) and by paying attention not to make the fluid overflow (we recommend to use a funnel only
for this operation), fill the tank (max. capacity of 4.5 l/1.2 US gal) by following the recommendations relating
to the batching that are reported on the detergent packaging; close the tank.
WARNING
• During the filling/topping-up operations of the Detergent tank, pay attention not to confuse the tanks. If you
pour detergent into the Diesel tank by mistake, do not use the water cleaner and apply to a
Skilled Technician
.
• As for the use mode, refer to the indications on the detergent packaging.
• Rotate the ring nut of the nozzle-holding head (18) as shown in Fig. 1-a and then activate the lever (24) of the
water gun and start to spray the detergent. Rotate the nozzle-holding ring nut (18) as shown in Fig. 2-b to reset
the high-pressure operation.
5.5 I
nterruptInG
u
se
(
total
stop
)
Release the lever (24) on the cleaner gun and the water cleaner will automatically stop.
The water cleaner starts operating normally again when the lever on the cleaner gun is pressed again.
WARNING
•
It is important to remember that the high pressure cleaner is still operational when it is in Total Stop mode. Therefore,
always put the main switch (2) in position “0”, remove the plug from the power outlet, press the lever (24) on the
cleaner gun to eliminate any remaining pressure and lock the safety protection device (25) (Fig. 1 - position S), before
leaving it unattended, even for a short time.
6 s
WItChInG
o
ff
and
s
toraGe
After cleaning, switch the water cleaner off and prepare it for storage.
6.1
s
WItChInG
o
ff
• Use the water cleaner with cold water for a couple of minutes.
• Close the tap for the water supply securely.
• Empty the water out of the water cleaner by pressing the lever (24) on the cleaner gun for a few seconds.
• Put the main switch (2) in position “0”
• Remove the plug from the power outlet.
• Press the lever (24) on the cleaner gun to eliminate any remaining pressure in the high-pressure pipe (7).
• Wait for the high pressure cleaner to cool down.
WARNING
• When the water cleaner is left to cool down, take care that:
- the water cleaner is not left unattended in the presence of unsupervised children, elderly or disabled people.
- the water cleaner is in a stable position and not at risk of falling over.
- the water cleaner is not in contact with inflammable materials, or in their immediate vicinity.