![background image](/i/freggia/142177/freggia-dwi4108/h/freggia-dwi4108-007.png)
To put rinse aid, remove the rinse aid compartment cap
by turning it.1 Fill the rinse aid compartment with rinse
aid until the rinse aid level indicator becomes dark; 2 refi t
the cap and close it by turning it in a way that the nails
will correspond to one another. By checking the rinse
aid level indicator on the detergent dispenser, you can
understand whether or not your machine needs rinse
aid. A dark indicator b means that there is rinse aid in the
compartment, while a light indicator a shows that you
need to fi ll the compartment with rinse aid.
The rinse aid level adjuster can be set to a position
between 1 and 6. Factory setting for rinse aid is the
position 3. You need to increase the degree of the
adjuster if water stains form on your dishes after a wash,
whereas you need to decrease the degree if a blue stain
is left when wiped by hand. 3
WARNING! Use only those rinse aid materials which are allowed for use in
the machine. As rinse aid residues left as a result of overfl owing will create
extremely high amounts of foam and thus reduce the washing performance,
remove the excess amount of rinse aid by wiping it with a rag.
LOADING YOUR DISHWASHER
If you properly place your dishes into the machine, you will be using it in the best way
in terms of energy consumption, washing and drying performance.
There are two separate baskets for you to load your dishes into your machine. You
can load into the lower basket such round and deep items as pots with long handles,
pot lids, plates, salad plates, cutlery sets.
The upper basket has been designed for tea plates, dessert plates, salad bowls,
cups and glasses. When placing long-stem glasses and goblets, lean them against
the basket edge, rack or glass supporter wire and not against other items. Do not
lean long glasses against one another or they cannot remain steady and may receive
damage.
It is more appropriate to locate the thin narrow parts into the middle sections of
baskets. You can place spoons among the other cutlery sets in order to prevent them
from sticking to one another. You are recommended to use the cutlery grid in order
to obtain the best result.
To avoid any possible injuries, always place such long-handle and sharp-pointed
dishes as serving fork, bread knife etc. with their sharp points facing down or
horizontally on the baskets.
WARNING! Place your dishes into your machine in a way that they will not
prevent the upper and lower spray arms from spinning.
TOP BASKET
• DISH
RACK
There are dish racks on the upper
basket of your machine. a b You
can use these dish racks in open
or closed position. When they are
in open position a you can place
your cups on them; and when in
closed position b you can place
long glasses on the basket.
Also, you can use these racks by placing long forks, knives and spoons on them
laterally.
FILLING THE DETERGENT COMPARTMENT
Push the latch to open the detergent container as shown in
the image. 1 Detergent pod has level lines inside. It is possible
to measure the right detergent amount using these lines.
Detergent pod can take totally 40 cm
3
detergent. Open the
dishwasher detergent and pour into the larger compartment
b 25 cm
3
if your dishes are heavily soiled or 15 cm
3
if they are
less soiled.2
If your dishes have been kept dirty for a very long time, if
there are dried food wastes on them, and if you have overly
loaded the dishwasher, pour a 5 cm
3
detergent into the
prewash compartment and start your machine. You may have
to add more detergent into your machine, depending on the
degree of soil and on the water hardness level in your area.
COMBINED DETERGENT
Detergent manufacturers also produce combined detergents called “2 in 1”, “3 in 1”
or “5 in 1” etc.
“2 in 1” detergents contain detergent + salt or rinse aid. When using “2 in 1” detergents
make sure to check the specifi cations of the tablet.
Other tablet detergents contain detergent + rinse aid + salt + varlous extra functions.
Generally, combined detergents produce suffi
cient results under certain usage
conditions only.
Such detergents contain rinse aid and/or salt in preset amounts
•
POINTS TO CONSIDER WHEN USING THIS TYPE OF PRODUCTS:
•
Always make sure to check the specifi cations of the product you will use
or whether or not it is a combined product.
•
Check if the detergent used is appropriate for the hardness of mains water
that machine is appertaining to.
•
Observe the instructions on packagings when using such products.
•
If such detergents are in the form of tablets, never put them into the
interior section or the cutlery basket of the dishwasher. Always put the
tablets into the detergent compartment in the detergent dispenser.
•
They produce good results for certain types of usage only. If you are using
this type of detergents, you need to contact the manufacturers and fi nd
out about the suitable conditions of use.
•
When the conditions of use of such products and the machine settings
are appropriate, they ensure savings in salt and/or rinse aid consumption.
•
Contact the detergent manufacturers if you are not obtaining good wash
results (if your dishes stay calcareous and wet) after having used 2 in 1 or
3 in 1 detergents. The scope of warranty for your machine does not cover
any complaints caused by the use of these types of detergents.
Recommended usage: If you are using a combined detergent, then add
rinse agent into your machine ,switch the rinse agent settings into its lowest
(1) position and active the tablet detergent button in order to obtain better
results.If the water hardness level is above level 4,then it is necessary to fi ll in
the salt container with salt.t is not recommended to use combined detergents
in fast programs.
WARNING: Should any problem, which you have not encountered before,
arise with the use of this type of detergents, contact the detergent
manufacturers directly.
•
WHEN YOU GIVE UP USING COMBINED DETERGENTS
•
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position ( 6 ) and run an
empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
FILLING WITH RINSE AID AND MAKING THE SETTING
Rinse aid is used to prevent the stay of white water drops,
lime stains, white fi lm strip-shaped stains that may form on
the dishes, as well as to increase the drying performance.
Contrary to the popular beliefs, it is used not only for
obtaining shinier dishes but also for obtaining suffi
ciently
dried dishes. For this reason, care should be taken that
there is adequate amount of rinse aid in the rinse aid
compartment and only polishing material produced for use
at dishwashers should be used. If the rinse aid lamp on the
control panel becomes on fi ll the rinse aid compartment
with rinse.
GB
7
PREPARING THE MACHINE FOR USE
PREPARING THE MACHINE FOR USE