This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations
are ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for
information on configurable product offerings and requirements.
1. Factory Integrated Models must start with a CTO Server.
2. FIO indicates that this option is only available as a factory installable option.
3. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
4. Some options may not be integrated at the factory. Contact your local sales representative for additional information.

Step 1: Base Configuration (choose one of the following configurable models)

[Chassis]

HP ProLiant ML350 Gen9
Hot Plug 8SFF Configure-to-
order Rack Server

HP ProLiant ML350 Gen9
Hot Plug 8SFF Configure-to-
order Tower Server

SKU Number

754534-B21

754536-B21

Processor

2 (optional) x HP Smart Socket Guides

DIMMSlots

24 DIMM slots for RDIMM, LRDIMM DDR4 Memory

Storage Controller

HP Dynamic Smart Array B140i

PCIe

9 Standard (8 FH/FL, 1 FH/HL)

Drive Cage

8SFF Hot Plug

Network Controller

HP Embedded 1Gb Ethernet 4-port 331i Adapter

Fans

3 hot plug fans, non redundant

Management

iLO Management (standard), Intelligent Provisioning

(standard), iLO Advanced (optional), Insight Control

(optional)

USB

2 front, 2 internal, 4 rear

Ears

Step 2: Choose Required Options (only one of the following from each list unless
otherwise noted)

HP Processors

Select one or two processors from Core options-Processor section below,

If one processor is desired, select one xxxxxx-L21
If two processors are desired, select one xxxxxx-L21 and one xxxxxx-B21.
Up to 2 processors supported. Mixing different processor models is not supported.
DDR4 speed is the maximum memory speed of the processor. Actual memory speed may
depend on the quantity and type of DIMMs installed.
For the Intel® C600 Chipset E5-2600 Series, the letter preceding the model number
indicates the
Product Line (E3, E5, E7); 2600x v#, 2 = number of CPUs in a Node, 4 is socket/segment
designation, 00 = Processor SKU, x = L for low power SKUs and v# (not yet designated) =
version number.

HP Memory

Select one or more memory from Core options-Memory section below,

LRDIMM, RDIMM are all distinct memory technologies and cannot be mixed within a server.
The majority of ProLiant Gen9 servers support LRDIMM and RDIMM.
HP memory from previous generation servers are not qualified or warranted with this HP
ProLiant Server. HP SmartMemory is required to realize the memory performance
improvements and enhanced functionality listed in this document for Gen9.
If only one processor is installed, only half of the total DIMM slots are available. When

QuickSpecs

HP ProLiant ML350 Generation9 (Gen9)

Configuration Information - Factory Integrated Models

DA - 15035   Worldwide QuickSpecs — Version 1 — 9.9.2014

Page  17