populating with two processors all DIMM slots are available.
Kits described as LP include Low Power DIMMs. For more information on ProLiant Energy
Efficient Features, see: 

www.hp.com/go/proliant-energy-efficient

.

Depending on the memory configuration and processor model, the memory speed may run
at 2133MHz, 1866MHz, 1600MHz or 1333MHz. Please see Memory Population Table or the
Online Memory Configuration Tool at: 

www.hp.com/go/ddr4memory-configurator

HP Power Supplies

Select one or more power supplies from Core Options-Power Supplies section below:

Prior to selecting a power supply option, it is highly recommended that you review your
server configuration in the HP Power Advisor tool to determine the right size power supply
for your server configuration. The HP Power Advisor is located at:

www.hp.com/go/hppoweradvisor

.

Mixing of power supplies in the same server is not supported. All power supplies must be of
the same input voltage, output rating, and efficiency rating. If non-matching power supplies
are installed, you may receive an error message and/or experience operational issues with
your server.

Step 3: Choose Additional Factory Integratable Options

HP Networking

Select a standup NIC adapter from Core options-Networking section below,

Please see the QuickSpecs for Technical Specifications and additional information:

www.hp.com/go/ProLiantNICs

These options are upgradeable and can be changed from the original configuration after the
server is shipped.
For 10Gb adapters, a minimum of two Gigabytes (2 GB) of server memory is required per
each adapter.

HP Drives

Select one or more drives from Core options-HP Drives section below:

The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and
the server backplane) should operate at the same data transfer rate or the system
bandwidth will be negotiated down to an acceptable level for all components.
Hard drives have either a one year or three year warranty; refer to the specific hard drive
QuickSpecs for details.
The HP ProLiant Gen9 Smart Storage solutions are equipped with re-designed Small Form
Factor (SFF 2.5 in) and Large Form Factor (LFF 3.5 in) hot plug carriers for HP Qualified
Hard Drives and Solid State Drives. These new carriers provide status and activity
indicators as well as caution indicators for "Do Not Remove".

HP Graphics Options

Select one or more graphics adapter from Additional options section below.

Please see the HP Power Advisor for estimated power consumption of your individual
system configuration prior to installing GPUs. The HP Power Advisor is located at:

www.hp.com/go/hppoweradvisor

HP Unique Options

Select one or more Unique options from Core options section below.

This section may contain FIO options, please see the Unique options section below.
FIO indicates that this option is only available as a factory installable option.

QuickSpecs

HP ProLiant ML350 Generation9 (Gen9)

Configuration Information - Factory Integrated Models

DA - 15035   Worldwide QuickSpecs — Version 1 — 9.9.2014

Page  18