20

On Screen Display(OSD) Selection and Adjustment 

Press the      ,     buttons to reset immediately.

SETUP

MENU

: Exit
: Adjust
: Adjust

SET    

: Select another  

sub-menu

Main menu

Sub menu

Description

To choose the language in which the control
names are displayed.

To adjust position of the OSD window on the
screen.

LANGUAGE

OSD
POSITION

R T C

If you set 

ON

, you enable the Response Time

Control function.
If you set 

OFF

, you disable the Response

Time Control function.  

Restore all factory default settings except

"LANGUAGE".

FACTORY
RESET

POWER
INDICATOR

Use this function to set the power indicator on the
front side of the monitor to 

ON

or 

OFF

.

If you set 

OFF

, it will go off. 

If you set 

ON

at any time, the power indicator will

automatically be turned on.

VOLUME

LIGHTING LEVEL

1920 x 1080

3

If this does not improve the screen image, restore the factory default settings. 
If necessary, perform the white balance function again. This function will be enabled only when
the input signal is an analog signal.

LIGHTING
LEVEL

The White LED will move from center of the
PCB depends on Sound input signal level.
If sound signal level is lower than Threshold
level, the LED cannot operate.
About LIGHTING LEVEL, you can change
from 0 to 10.
If No sound input, the LED has no action.

OVERSCAN

To select the range of output image for DTV
timing in HDMI input.
(only for HDMI input)
Recommend overscan function to turn on when
connect AV equipment.

VOLUME

To adjust the volume of headphone/Earphone.