7 -
Initial installation
Select IP Address Assignment Method
Select IP Address
Assignment Method
.
OK Activate
.
Automatic (DHCP):
IP addresses are automatically issued
by a DHCP server on your home network.
➠
A DHCP server has to be set up on a device on the
network (e.g. WLAN router).
Input Static IP Address:
IP addresses are entered
manually.
Digit buttons:
Input digits of IP address.
EPG:
Enter
dots.
Function of coloured buttons:
Yellow:
Delete last position.
Red:
Delete address.
OK:
Adopt
IP address.
Proceed similarly with the subsequent entry of the further
IP addresses of Subnet Mask, Gateway and DNS server.
Network setting
Afterwards you will see a summary of the settings.
OK
Adopt settings.
Backwards step by step for changes.
Select Server
Lastly, select the media server from which you want to
draw the data.
Select media server
.
OK
Activate
.
If your required media server should not be found the
first time, then you can press the
red button
to
Rescan
for media servers.
Connectivity display
After successful initial installation, the media selection opens up
(page 8) and the
Connectivity display
on the left of the TV set lights
up. The Connectivity display can, if required, be switched off via the
MediaNetwork-Menu (page 9).
OK
END
Network setting
Adopt
Adopt the following settings?
Network mode:
Wireless
SSID:
WLAN-Router_1
Device IP address: 192.168.1.123
Subnet Mask:
255.255.255.0
Gateway address: 192.168.1.1
DNS address:
192.168.1.1
END
OK
OK
Select IP Address Assignment Method
Automatic (DHCP)
Input Static IP Address
Activate
192.168.1.123_
OK
-
0
9
END
EPG
Set device IP address
Adopt
Input digits
Delete address
Delete last position
Input
"
.
"
OK
OK
Media-Server 1
Media-Server 2
Media-Server 3
Select source / media server
Activate
Rescan
english