![background image](/i/pentax/155786/pentax-optio-i-10-en/h/pentax-optio-i-10-en-211.png)
210
7
S
e
ttings
4
Use the four-way controller
(
45
) to choose the image for
the start-up screen.
Only images suitable for the start-up
screen are displayed. You can also
choose one of the 3 pre-installed
screens or the Guide Display Start-up
Screen already stored in the camera.
5
Press the
4
button.
The start-up screen is set.
Pixel Mapping is a function for mapping out and correcting defective
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
1
Press the
3
button in
A
mode, and press the four-
way controller (
5
).
The [
W
Setting] menu appears.
[Pixel Mapping] cannot be selected when the
3
button is pressed
in
Q
mode.
2
Use the four-way controller (
23
) to select [Pixel
Mapping].
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card is formatted.
• Select [Off] to hide the start-up screen.
• The start-up screen is not displayed when the camera starts up in the
playback mode.
Correcting Defective Pixels in the CCD Sensor
(Pixel Mapping)
100-0017
100-0017
100-0017
OK
OK
OK
OK
OK
OK
MENU
MENU
Cancel
Cancel
MENU
Cancel
e_kb494.book Page 210 Wednesday, February 3, 2010 5:12 PM