![background image](/i/pentax/155786/pentax-optio-i-10-en/h/pentax-optio-i-10-en-095.png)
94
3
Ta
kin
g
Pictur
es
4
Press the shutter release button on the remote control
unit.
When
i
(3-sec Remote Control) is selected: The focus frame turns
green at the point where the focus is achieved and the camera takes
a picture after about three seconds.
When
h
(0-sec Remote Control) is selected: The camera takes a
picture immediately.
In
X
(Digital Wide) mode, you can stitch two vertical images captured
with this camera into a single frame up to approx. 21 mm coverage (35
mm film equivalent).
• The operating range is approx. 4 m (13 ft) from the front of the camera
when using the remote control unit.
• In
C
(Movie) mode, pressing the shutter release button again stops
the recording.
• The camera takes a picture even if the focus is not achieved.
• In Remote Control mode, the self-timer lamp blinks. When the camera
receives a shutter release signal, the self-timer lamp blinks quickly
right before and after the shot takes place. Also, when the camera
receives a zoom signal, the self-timer lamp blinks quickly.
• If the shutter release button is pressed halfway during the countdown,
the countdown stops. If the shutter release button is pressed fully, the
camera starts the countdown again.
•
i
/
h
cannot be selected in
9
(Green) mode.
Using the Digital Wide Function
(Digital Wide Mode)
+
e_kb494.book Page 94 Wednesday, February 3, 2010 5:12 PM