Страница 3 из 21 SUMMARY INSTALLATION HOW TO USE YOUR CB 5 8 PROTECTION BY SECURITY CODE SYSTEM 14 TECHNICAL CHARACTERISTICS 16 TROUBLE SHOOTING 16 HOW TO TRANSMIT OR RECEIVE A MESSAGE 16 GLOSSARY 17 FREQUENCY TABLES 21 3
Страница 4 из 21 WARNING ! Before using, be careful never to transmit without first having connected the antenna (connection B situated on the back panel of the equipment) or without having set the SWR (Standing Wave Ratio) ! Failure to do so may result in destruction of the power amplifier, which is not covered by
Страница 5 из 21 Welcome to the world of the 3rd generation of CB radios. The new PRESIDENT INTERACTIVE range gives you access to top performance CB equipment. With the use of upto-date technology, which guarantees unprecedented quality, your PRESIDENT GEORGE is a new step in personal communications and is the
Страница 6 из 21 2) ANTENNA INSTALLATION: 3) POWER CONNECTION: a) Choosing your antenna: - For CB radios, the longer the antenna, the better its results. Your dealer will be able to help you with your choice of antenna. Your PRESIDENT GEORGE is protected against an inversion of polarities. However, before switching
Страница 7 из 21 e) Press the «METER» key, with the «push-to-talk» switch pressed down, so that the equipment is in S/RF mode. 4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING YOUR SET FOR THE FIRST TIME (without trans-mitting and without using the «push-to-talk» switch on the microphone): DISPLAY a) Connect the
Страница 8 из 21 * Using an external SWR meter (e.g. SWR 1 or SWR 2 PRESIDENT): 4) VOLUME: a) To connect the SWR meter: - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type CA 2C PRESIDENT). b) To adjust the SWR meter: - Set the CB to
Страница 9 из 21 Example: 8) RF POWER: When you turn this knob fully clockwise the RF power (norm peak 4 watts) is at maximum. You should reduce transmission power when the communication is close to someone who does not have RF GAIN. Configuration You are in Channel 22, FM. The normal setting of this knob is on
Страница 10 из 21 else disappears. Hold the microphone far enough away from this loud speaker so as to avoid the Larsen effect. 14)NB/ANL: Noise Blanker/ Automatic Noise Limiter. These filters allow the reduction of back ground noise, and some reception interference. The PA volume is regulated by the MIC GAIN knob.
Страница 11 из 21 - Press «CH ▲» (+ 10 channels): Set goes to the channel 32 FM. 20)CH 19 (Channel 19 AM): Channel 19 AM is automatically selected when you depress this key. Configuration You are in Channel 22 FM. - Press «CH ▲» (+ 10 channels): Set goes to the channel 2 FM. - Press «CH19»: Frequency disappears to
Страница 12 из 21 - - If a signal is detected on Channel 22 your CB listens to the channel and stays there until the end of the signal. Press «CH19» Set goes directly to Channel «CH19». - End of signal on Channel 22 FM. 21)DW (Dual Watch): This function lets you watch over Channel 19 AM and the channel you are
Страница 13 из 21 By immediately pressing one of the memory keys (M1 - M4) the channel and the modulation mode currently in use will be stored in the memory. The operation is validated with a long beep. (See example after paragraph 23) - Depression of «M1»: stops flashing, appears, long beep sounds to indicate that
Страница 14 из 21 b) Direct access to one of the memories, Initial configuration Channel 3 LSB. 24)SCAN: This function allows you to “scan” all the memorised channels (16). Scanning stops when a signal is detected on one of the memorised channels. At the end of the signal, scanning continues. By going into
Страница 15 из 21 - if the 12 volt power supply is deconnected and/or - after a long depression (more than four seconds) of the POWER key (radio on or off). In these two cases, the CB is blocked and it is necessary to enter the correct access code. The access code, established by PRESIDENT in the factory or after
Страница 16 из 21 D) TECHNICAL CHARACTERISTICS: E) TROUBLE SHOOTING: 1) GENERAL: - Channels - Modulation modes - Frequency ranges - Antenna impedance - Power supply - Dimensions (en mm) - Weight - Accessories supplied : : : : : : : : 40 AM/FM/LSB/USB from 26.965 MHz à 27.405 MHz 50 ohms 13.2 V 200 (L) x 207.5 (H) x
Страница 17 из 21 Press the «push-to-talk» switch and announce your message «Attention stations, transmission testing» which will allow you to check the clearness and the power of your signal. Release the switch and wait for a reply. You should receive a reply like, «Strong and clear». If you use a calling channel
Страница 18 из 21 FREQUENCY TABLES CERTIFICATE OF CONFORMITY Channel Kanal Frequency Frequenzens Channel Kanal Frequency Frequenzens 1 26,965 MHz 21 27,215 MHz 2 26,975 MHz 22 27,225 MHz 3 26,985 MHz 23 27,255 MHz 4 27,005 MHz 24 27,235 MHz 5 27,015 MHz 25 27,245 MHz 6 27,025 MHz 26 27,265 MHz 7 27,035 MHz 27 27,275
Страница 19 из 21 Pays dans lesquels il existe des limitations particulières (Licence1 / Registre2 / seulement du canal 4 à 123) Countries in which there are particular restrictions Países en los cuales existe algún tipo de limitación (Licencia1 / Registro2 / solo del canal 4 a 123) Länder mit besonderen
Страница 20 из 21 0233/03-01 SIEGE SOCIAL/HEAD OFFICE - FRANCE Route de Sète - BP 100 - 34540 BALARUC Site Internet : http://www.president-electronics.com E-mail : groupe@president-electronics.com
