![background image](/i/president/155551/president-george-asc/h/president-george-asc-015.png)
15
- if the 12 volt power supply is deconnected
and/or
- after a long depression (more than four seconds) of the POWER key (radio on
or off). In these two cases, the CB is blocked and it is necessary to enter the
correct access code. The access code, established by PRESIDENT in the
factory or after being returned to the After Sales Service department is:
4 short depressions of the
PROGRAM key.
WARNING
:
If you forget your access code, you are advised to contact your
dealer. We strongly advise you to make a note of your code.
HOW TO PERSONALIZE YOUR ACCESS CODE:
Please carefully read this procedure before changing the access code.
a)
Turn your CB on by pressing «POWER».
b)
Turn your CB off by pressing «POWER».
c)
Depress «POWER» and keep depressed: your CB goes on and then goes off.
d)
Depress both «NB/ANL» and «PROGRAM» while keeping «POWER» depressed.
e)
Release «POWER», but keeping «NB/ANL» and «PROGRAM» depressed:
flashes in the display for 5 seconds.
f)
When
disappears: Release the keys «NB/ANL» and «PROGRAM».
g)
flashes again. You have 20 seconds in which to enter the old code.
h)
Press the first key of the old code («PROGRAM» in the original configuration)
appears in the display.
i)
Press the second key of the old code («PROGRAM» in the original configuration)
appears in the display.
j)
Press the third key of the old code («PROGRAM» in the original configuration)
appears in the display.
k)
Press the fourth key of the old code («PROGRAM» in the original configuration).
A beep sounds and the letter
appears in the display which indicates that
your radio CB is ready to register the new code (4 key code).
l)
Depress the first key of the new code choosing between «M1», «M2», «M3»,
«M4», and «PROGRAM»: appears in the display as well as the letter
.
m)
Depress the second key of the new code choosing between «M1», «M2»,
«M3», «M4», and «PROGRAM»: appears in the display as well as the letter
.
n)
Press the third key of the new code choosing between «M1», «M2», «M3», «M4»,
and «PROGRAM»:
appears in the display as well as the letter
.
o)
Press the fourth key of the new code choosing between «M1», «M2», «M3»,
«M4», and «PROGRAM» : The display goes out.
p)
Depress «POWER»: your CB lights up and the new code is memorised.
- If you make a mistake while entering the old access code, press any key
(several times if necessary) until
flashes in the display and then continue
from step
g)
.
- If, while entering the new access code, you press a key other than «M1», «M2»,
«M3», «M4», or «PROGRAM» (eg SCAN) your CB automatically goes to point
l)
.
6-PIN MICROPHONE PLUG
1
Modulation
2
RX
3
TX
4
Up/Down
5
Masse
6
Alimentation