Regulatory information 

FCC Regulations state that changes or modifications to this equipment not 
expressly approved by the manufacturer could void the user’s authority to 
operate this equipment. In the event that terminal equipment causes harm 
to the telephone network, the telephone company should notify the 
customer that service may be stopped. However, where prior notice is 
impractical, the company may temporarily cease service, providing that 
they: 

a 

promptly notify the customer. 

b 

give the customer an opportunity to correct the equipment problem. 

c 

inform the customer of the right to bring a complaint to the Federal 
Communication Commission pursuant to procedures set out in FCC 
Rules and Regulations Subpart E of Part 68. 

You should also know that: 

•  

Your machine is not designed to be connected to a digital PBX system. 

•  

If you intend to use a computer modem or fax modem on the same phone 
line as your machine, you may experience transmission and reception 
problems with all the equipment. It is recommended that no other 
equipment, except for a regular telephone, share the line with your 
machine. 

•  

If your area experiences a high incidence of lightning or power surges, we 
recommend that you install surge protectors for both the power and the 
telephone lines. Surge protectors can be purchased from your dealer or 
telephone and electronic specialty stores. 

•  

When programming emergency numbers and/or making test calls to 
emergency numbers, use a non-emergency number to advise the 
emergency service dispatcher of your intentions. The dispatcher will give 
you further instructions on how to actually test the emergency number. 

•  

This machine may not be used on coin service or party lines. 

•  

This machine provides magnetic coupling to hearing aids. 

You may safely connect this equipment to the telephone network by means of 

a standard modular jack, USOC RJ-11C. 

Replacing the Fitted Plug (for UK Only) 

Important 

The mains lead for this machine is fitted with a standard (BS 1363) 13 amp plug 

and has a 13 amp fuse. When you change or examine the fuse, you must re-fit 

the correct 13 amp fuse. You then need to replace the fuse cover. If you have lost 

the fuse cover, do not use the plug until you have another fuse cover. 

Contact the people from you purchased the machine. 

The 13 amp plug is the most widely used in the UK and should be suitable. 

However, some buildings (mainly old ones) do not have normal 13 amp plug 

sockets. You need to buy a suitable plug adaptor. Do not remove the moulded 

plug. 

5. Appendix 

88