GB
7
PREPARING THE MACHINE FOR USE
PREPARING THE MACHINE FOR USE
LOADING YOUR DISHWASHER
•
When the conditions of use of such products and the machine settings
are appropriate, they ensure savings in salt and/or rinse aid consumption.
•
Contact the detergent manufacturers if you are not obtaining good wash
results (if your dishes stay calcareous and wet) after having used 2 in 1 or
3 in 1 detergents. The scope of warranty for your machine does not cover
any complaints caused by the use of these types of detergents.
Recommended usage
If you want to obtain better results while using combined detergents, add salt
and rinse aid into your machine and adjust the water hardness setting and the
rinse aid setting to the lowest position.
WARNING! Solubility of the tablet detergents produced by diff erent
companies can vary depending on the temperature and time. Therefore,
it is not recommended to use such detergents in short programs. It is
more suitable to use powder detergents in such programs.
WARNING!
Should any problem, which you have not encountered before, arise with
the use of this type of detergents, contact the detergent manufacturers
directly.
•
WHEN YOU GIVE UP USING COMBINED DETERGENTS
•
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position ( 6 ) and run an
empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
FILLING WITH RINSE AID AND MAKING THE SETTING
Rinse aid is used to prevent the stay of white water
drops, lime stains, white fi lm strip-shaped stains that
may form on the dishes, as well as to increase the
drying performance. Contrary to the popular beliefs,
it is used not only for obtaining shinier dishes but also
for obtaining suffi
ciently dried dishes. For this reason,
care should be taken that there is adequate amount
of rinse aid in the rinse aid compartment and only
polishing material produced for use at dishwashers
should be used. If the rinse aid lamp on the
control panel becomes on fi
ll the rinse aid
compartment with rinse.
To put rinse aid, remove the rinse aid compartment
cap by turning it.1 Fill the rinse aid compartment with
rinse aid until the rinse aid level indicator becomes
dark; 2 refi t the cap and close it by turning it in a
way that the nails will correspond to one another. By
checking the rinse aid level indicator on the detergent
dispenser, you can understand whether or not your
machine needs rinse aid. A dark indicator b means
that there is rinse aid in the compartment, while
a light indicator a shows that you need to fi ll the
compartment with rinse aid.
The rinse aid level adjuster can be set to a position between 1 and 6. Factory setting
for rinse aid is the position 3. You need to increase the degree of the adjuster if water
stains form on your dishes after a wash, whereas you need to decrease the degree if
a blue stain is left when wiped by hand. 3
WARNING! Use only those rinse aid materials which are allowed for use
in the machine. As rinse aid residues left as a result of overfl owing will
create extremely high amounts of foam and thus reduce the washing
performance, remove the excess amount of rinse aid by wiping it with a
rag
LOADING YOUR DISHWASHER
If you properly place your dishes into the machine, you will be using it in the best way
in terms of energy consumption, washing and drying performance.
There are two separate baskets for you to load your dishes into your machine. You
can load into the lower basket such round and deep items as pots with long handles,
pot lids, plates, salad plates, cutlery sets.
The upper basket has been designed for tea plates, dessert plates, salad bowls,
cups and glasses. When placing long-stem glasses and goblets, lean them against
the basket edge, rack or glass supporter wire and not against other items. Do not
lean long glasses against one another or they cannot remain steady and may receive
damage.
It is more appropriate to locate the thin narrow parts into the middle sections of
baskets. You can place spoons among the other cutlery sets in order to prevent them
from sticking to one another. You are recommended to use the cutlery grid in order
to obtain the best result.
To avoid any possible injuries, always place such long-handle and sharp-pointed
dishes as serving fork, bread knife etc. with their sharp points facing down or
horizontally on the baskets.
WARNING! Place your dishes into your machine in a way that they will not
prevent the upper and lower spray arms from spinning.
TOP BASKET
• DISH
RACK
There are dish racks on the upper
basket of your machine. a b You
can use these dish racks in open
or closed position. When they are
in open position a you can place
your cups on them; and when in
closed position b you can place
long glasses on the basket.
Also, you can use these racks by placing long forks, knives and spoons on them
laterally.
•
TOP BASKET HEIGHT ADJUSTMENT WHILE IT IS FULL
Basket height adjustment mechanism on the top basket of your machine is designed
to let you adjust the height of your top basket upwards or downwards, without
removing it from your machine when it is full, and create large spaces at the top
or bottom area of your machine as needed. Basket of your machine is set to upper
position in factory settings.
In order to raise your basket, hold it from both sides and pull it upwards. In order
to lower it, hold it from both sides again, and leave it. In loaded basket adjustment
mechanism, make sure that both sides are in the same position (up or down).
Foldable racks on the upper basket are designed in order to let you place big items
easier such as pots, pans, etc. If requested, each part can be folded separately, or all
of them can be folded and larger spaces can be obtained.You can use foldable racks
by raising them upwards, or by folding down.
LOWER BASKET
• FOLDING
RACKS
Folding racks consisting of two parts that are located on the lower basket of your
machine are designed in order to let you place big items easier such as pots, pans,
etc. If requested, each part can be folded separately, or all of them can be folded and
larger spaces can be obtained.
You can use folding racks by raising them upwards, or by folding them down.
