Инструкция для Freggia HA631VGTB, HR750VGTAN, HA640VB, HA640VW, HR750VGTCH, HA640VGX, HA640VGTB, HA640VGTW, HA640VX, HA750VGTX, HA640VGTX, HA631VGTX, HA631VGTW, HA750VGTB
![background image](/i/freggia/134789/freggia-ha631vgtb-hr750vgtan-ha640vb-ha640vw-hr750vgtch-ha640vgx-ha640vgtb/h/freggia-ha631vgtb-hr750vgtan-ha640vb-ha640vw-hr750vgtch-ha640vgx-ha640vgtb-014.png)
14
INSTRUCTIONS FOR THE INSTALLER
CLEANING
Before any operation, disconnect the appliance from the electric grid.
Don’t use a steam cleaner for the cleaning the hob.
It is advisable to clean the appliance when it is cold.
• ENAMELLED PARTS
The enamelled parts must be washed with a sponge and soapy water or with a light detergent.
Do not use abrasive or corrosive products.
Do not leave substances, such as lemon or tomato juice, salt water, vinegar, coffee and milk on the enamelled surfaces
for a long time.
• STAINLESS STEEL PARTS
Stainless steel can be stained if it remains in contact with highly calcareous water or aggressive detergents for an
extended period of time.
The stainless steel parts should also be cleaned with soapy water and then dried with a soft cloth.
• BURNERS AND RACKS
These parts can be removed to make cleaning easier.
The burners must be washed with a sponge and soapy water or with a light detergent, wiped well and placed in their
housing perfectly. Make sure that the flame-dividing ducts are not clogged.
Check that the feeler of the safety valve and the start-up electrode are always perfectly cleaned, so as to ensure an
optimum operation.
• GAS TAPS
The possible lubrication of the taps must be carried out by specialized personnel, exclusively.
In case of hardening or malfunctions in the gas taps, apply to the Customer Service.
INSTRUCTIONS FOR THE INSTALLER
IMPORTANT NOTICE:
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL EXCLUSIVELY,
IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE, ANIMALS OR
THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS.
INSTALLATION
• INSTALLING THE TOP
The appliance is designed to be embedded into heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a temperature of 75°C besides the room one.
The equipment must not be installed near inflammable materials, such as curtains, cloths, etc. Make a hole in the top
of the piece of furniture, with the dimensions indicated in fig. 3, at a distance of at least 50 mm from the appliance
border to the adjacent walls.
INSTRUCTIONS FOR THE USER