GB
7
ASSEMBLY INSTRUCTION
BEFORE CALLING YOUR AFTER SALES SERVICE
Climate Class
Ambient Temperature
o
C
T
Between 16 and 43 (°C)
ST
Between 16 and 38 (°C)
N
Between 16 and 32 (°C)
SN
Between 10 and 32 (°C)
If there is noise;
The cooling gas which circulates in the refrigerator circuit may make a
slight noise (bubbling sound) even when the compressor is not running.
Do not worry, this is quite normal. If these sounds are different check if;
•
The appliance is installed firmly as described in the Installation Manual.
•
The objects on the appliance are vibrating.
If there is water in the lower part of the refrigerator;
Check if;
The drain hole for defrost water is not clogged (use defrost drain plug to
clean the drain hole).
If the door is not being properly opened and closed:
•
Are the food packages preventing the door from being closed?
•
Have the door compartments, shelves and drawers been properly placed?
•
Have the door seals been defective or torn?
•
Is your refrigerator standing on an even ground?
If your fridge is not cooling enough;
•
Your fridge is designed to operate in the ambient temperature intervals
stated in the standards, according to the climate class stated in the
information label. We do not recommend operating your fridge out of
stated temperatures value limits in terms of cooling effectiveness.
• RECOMMENDATIONS
•
In order to increase space and improve the appearance, the “cooling
section” of refrigerators is positioned inside the back wall of the refrigerator
compartment. When the compressor is working, this wall is covered with
frost or water drops. Do not worry. This is quite normal.
•
The appliance should be defrosted only if an excessively thick ice layer
forms on the back wall.
•
If the appliance is not used for a long time (for example during the summer
holidays), set the thermostat knob to position “ ”. Defrost and clean the
refrigerator leaving the door open to prevent the formation of mildew and
smell.
TIPS FOR SAVING ENERGY
1.
Install the appliance in a coll, well vantilated room , but not in direct
sunlight and not near heat source (radiator, cooker.. etc). Otherwise use
an insulating plate.
2.
Allow ward food and drinks to cool down outside the appliance.
3.
When placing, drinks and slops they must be covered. Otherwise
humidity increases at the appliance. Therefore the working time gets
longer. Also covering drinks and slops helps to save smell and taste.
4.
When placing food and drinks, open the appliance door as briefly as
possible.
5.
Keep close the covers of any different temrepature compartment in the
appliance (crisper, chiller ...etc ).
6.
Door gasket must be clean and pliable. Replace gaskets if worn.