- 77 -

Appendix

In the following procedure, we'll create RAID 0 as an example.
1.  Under the RAID Mode section, press the <SPACE> key to select RAID 0.
2.  Set the Stripe Block size. 64 KB  is the default. 
3.  Under the Drives Assignments section, press the up or down arrow key to highlight a drive.
4.  Press the <SPACE> key or <Y>to change the Assignment option to Y. This action adds the drive to the 

disk array. The Drv section will show the number of disks assigned. 

5.  Press <Ctrl>+<Y> keys to save the information. The message in Figure 6 will appear. Press <Ctrl+Y> to 

input the array name. If you do not input the array name, the default array name will be used.  

Figure 7

Figure 8

7. Then, the message in Figure 8 will appear. Press <Ctrl>+<Y> to set the capacity of the RAID array or 

press other keys to set the array to its maximum capacity. 

Figure 6

6. When the next message appears, press <Ctrl>+<Y> to clear the MBR or press other keys to ignore this 

option. 

8. After the creation is complete, the screen will return to LD View Menu where you will see the newly-

created array.

9. Press <Esc> to return to Main Menu and press <Esc> again if you want to exit the RAID BIOS utility.

Fast Initialization Option has been selected

It will erase the MBR data of the disk.

<Press Ctrl-Y Key if you are sure to erase it>

<Press any other key to ignore this option>

Press Ctrl-Y to Modify Array Capacity or press any 

other key to use maximum capacity...

Please press Ctrl-Y key to input the LD Name

or press any key to exit.

If you do not input any LD name, the default

LD name will be used.