16

Start-up and operation

Select the center signal on the subwoofer

Use the ”Center to” switch to set whether the
center signal is to be reproduced via the Loewe
TV speakers or by a separately installed center
satellite speaker.
Switch pressed = center via TV set
Switch not pressed = center via satellite speaker
When connecting directly to TV sets with Master
Unit or signal box and direct connection to
Articos 55, this switching is not possible because
the center signal is always played back over the
TV speakers.

Switching the subwoofer on/off

You switch the Tremo speaker system on with the
ON/OFF switch.
If the subwoofer is connected to a Loewe TV set,
the Loewe DVD Preceiver or the Certos system,
you no longer need to switch on and off on the
subwoofer. After switching on the subwoofer for
the first time it is always subsequently switched
on and off automatically with the Loewe device.

Settings on the TV set
Sound via ...

If the Tremo speaker system is connected to the
Dolby Digital Module of the TV set:
1. Call the TV menu with 

M

 or 

MENU

.

2. Select ”Sound” with the arrow buttons 

.

3. Call the Sound menu with 

OK

.

4. Select the menu item ”Sound via” in the

Sound menu with the arrow buttons 

.

5. Select ”Tremo” with the arrow buttons 

and confirm with 

OK

.

Now the sound of the TV set is transmitted by
the satellite speakers and the subwoofer.

Note: If Tremo is not selectable on your Loewe TV
in the TV menu - Sound -  under ”Sound via”,
have your dealer do a software update.

Setting listener/speaker distances and
adjusting speaker volumes

Setting of the listener/speaker distances and
adjusting of the speakers to the same volume are
carried out according to the operating instruc-
tions of the Dolby Digital Module, the Certos
system or the DVD Preceiver. Set the ”Bass Inten-
sity” knob on the subwoofer to the center posi-
tion before adjusting the speaker volumes.

Sound reproduction via Loewe TV (from
MediaPlus chassis Q2500) with Tremo
speaker system connected

If you temporarily do not want to use the Tremo
speaker system and want to broadcast the sound
exclusively through the Loewe TV speakers, select
Sound – Sound via – ”TV” in the TV menu as
described above. Confirm with the 

OK

 key.

Note:
But please note the following for TV sets as of
software 4.4: If you have switched over to sound
reproduction via TV as described above, the
subwoofer may not be disconnected from the
mains or switched off with the ON/OFF switch or
the cubic plug cable pulled out.
If you have done this, the sound is reproduced via
the Tremo speaker system after switching the
subwoofer back on or after plugging in the cubic
plug or mains plug.
In such a case you have to switch the TV off and
back on so that the Tremo speaker system knows
that you only want to hear the sound over the TV
set.

Phase switch/bass intensity

The phase switch and the bass intensity knob
enable you to optimise bass reproduction.

We recommend you to proceed as follows:
• If the subwoofer is in the corner of the room,

set the bass intensity knob to ”Min”.

• If the subwoofer is against a wall, set the

bass intensity knob to the center position.

• If the subwoofer is standing freely in the

room, set the bass intensity knob to ”Max”.

• Start playing a DVD for example.
• Have a second person activate the phase

switch whilst you sit and listen.

• Decide for yourself which switch position

reproduces the best bass sound.

• Also set the bass intensity to suit your taste.

BA31673_002Tremo_GB_5

31.08.2004, 13:18 Uhr

16